Kenmore 318205869A manual Removing and Replacing the Lift-Off Oven Door, To Remove Oven Door

Page 23

General Care & Cleaning (cont’d)

Removing and Replacing the Lift-Off Oven Door

Door Hinge locations

with oven door fully open

Fig. 1

Fig. 2

Around

Oven door

Hinge

Fig. 3

Roller pin

Hinge arm hook

Hinge arm notch

Slot bottom

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open oven door completely (horizontal with floor - See Fig. 1).

2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Fig. 2). A tool such as a small flat- blade screwdriver may be required.

3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3).

4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).

5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Fig. 4).

To Replace Oven Door:

1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3).

2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm onto the roller pins located on each side of the oven door frame (See Fig. 4). Also, seat the notch of the hinge arm onto the bottom of the slot at the same time you seat the hook. The hook and notch of the hinge arms must be fully seated onto the roller pins and bottom of the slot.

3.Fully open the oven door (horizontal with floor - See Fig. 1).

4.Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Fig. 2) to the locked position.

5.Close the oven door.

Special Door Care Instructions - Most oven doors contain glass that can break. Read the following recommendations:

1.Do not close the oven door until all the oven racks are fully in place.

2.Do not hit the glass with pots, pans, or any other object.

3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

Fig. 4

23

Image 23
Contents Kenmore Table of Contents Important Safety Instructions Do not leave children alone-Children should Where appliance is in use. They should neverWhile using the appliance. Do not let clothing When heating fat or grease, watch it closelySave These Safety Instructions Conversion to Liquefied Petroleum Gas or L.P. Gas Grounding InstructionsYour Slide-in Range Features At a Glance Slide-in Range FeaturesControl Locations of the Gas Surface Burners Before Setting Surface ControlsFlame Size Type of Cooktop Setting Surface ControlsSetting Proper Surface Burner Flame Size Operating the Gas Surface ControlsUse Proper Cookware Using a wokSurface Cooking Arranging Oven Racks Before Setting Oven ControlsOven Vent Location Removing and Replacing Oven RacksControl Pad Functions Setting Oven ControlsTo Set the Clock To Set the Minute TimerTemperature conversion To Change the Minute Timer while it is in useTo Set Control for Oven Lockout To Set or Change the Temperature for BakingTo Set Control for Continuous Bake or 12 Hour Energy Saving Oven Baking Cooking InformationWhen the Set Bake Time Runs Out To Set the Timed Bake and Delay Start FeaturesBroil Rack Position Table Refer to Fig Food category Setting Oven Controls cont’d To Set for BroilingTo set Warm & Hold to turn on automatically Setting the Warm & Hold FeatureTo Operate the Oven Light To set Warm & HoldOven Cleaning Self-CleaningTo Adjust Oven Temperature Self-Clean Time LengthAdjusting the Oven Temperature Cleaning Various Parts of Your Range General Care & Cleaning3rd General Care & Cleaning cont’dCleaning the Cooktop, Burner Heads, Caps & Grates To Replace Oven Door Removing and Replacing the Lift-Off Oven DoorDoor Hinge locations With oven door fully open To Remove Oven DoorStorage Drawer Changing Oven LightCode error for exemple F11 Solutions to Common ProblemsAppliance must be accessible for ServiceFan noise during cooking operation Self-cleaning cycle does not workCleaning cycle Poor baking resultsProtection Agreements Get it fixed, at your home or ours Cuisinière encastrable Enregistrement de l’appareil Emplacementdelaplaque de sérieTable des matières Garantie sur appareil KenmoreNe modifiez jamais l’appareil, que ce soit en Entretien par l’usager-Ne réparez pas ou neLe faites, un empoisonnement au monoxyde de Carbone pourrait en résulter et l’appareil pourraitMesures de sécurité importantes Ne laissez jamais les brûleurs sans surveillance Fours autonettoyantsConversion au gaz propane Instructions de mise à la terreFour autonettoyant Caractéristiques de l’appareilEmplacement des commandes des brûleurs de surface Avant de régler les commandes des brûleurs de surfaceType de cuisson Réglage des commandes des brûleurs de surfaceRéglage de la bonne dimension de la flamme Emploi des brûleurs de surfaceUtilisation d’UN wok Cuisson sur la table de cuissonUstensiles pour la cuisson sur les brûleurs Enlever et replacer les grilles de four Avant de régler les commandes du four suiteInstallation des grilles Position de l’éventFonctions des touches de la commande du four Réglage de la commande du fourConversion de la température Pour un tableau de commande silencieuxRéglage de lhorloge Réglage de la minuteriePour régler la fonction de verrouillage Pour régler la commande du four pour la cuisson au fourRéglage de la fonction de verrouillage du four Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Catégorie d’aliment Cuisson au grilRéglage de la fonction Garder ChaudMD Réglage de la fonction Garder ChaudMDFonctionnement de la lampe du four Préparation du four avant le cycle autonettoyant Cycle autonettoyantNettoyage du four Prenez les précautions de nettoyage qui suiventArrêt ou interruption d’un cycle autonettoyant Durée du cycle autonettoyantAjustement de la température du four La fin du cycle autonettoyantEntretien général & nettoyage 1er Entretien général & nettoyage suitePour replacer la porte du four Nettoyage de l’acier inoxydableEnlever et replacer la porte du four Pour enlever la porte du fourTiroir de rangement Remplacement de l’ampoule du four’appareil n’est pas de niveau Solutions aux problèmes les plus fréquentsFacilement. Il doit être accessible La commande du four sonne etAutonettoyant La flamme est orangeLe four dégage beaucoup de fumée Durant la cuisson au gril Tion Réglage du fourContrats DE Protection Get it fixed, at your home or ours