Kenmore 318205869A manual Setting Oven Controls, Control Pad Functions

Page 12

Setting Oven Controls

Control Pad Functions

Read the instructions carefully before using the oven. For satisfactory use of your oven, become familiar with the various functions of the oven as described below.

NOTE: To activate the touch control, you just have to touch the pad with a finger. Take care to have a good contact be- tween the finger and the touch pad. Long nails can make the activation difficult. It is a good idea to clean the control panel after each use or as soon as possible after a spill, boil over or spatter because some ionic or salty ingredients as ketchup, tomatoes sauce, etc. can operate the control. Before cleaning the control panel it is recommended to turn on the control lockout feature.

Note: The time of day must first be set in order to operate the oven.

1 2

4

5

3

6

13

 

7

8

9

10

11

12

1.OVEN INTERIOR LIGHT PAD— Used to turn oven interior light ON or OFF.

2.CLOCK SET PAD— Used to set the time of day.

3.COOK TIME PAD— Used to enter the length of the baking time.

4.CLEAN PAD— Used to select the Self-Cleaning cycle. A 2, 3 or 4 hour Self-Clean time may be selected.

5.TIMER PAD— Used to set or cancel the minute timer. The minute timer does not start or stop cooking. Also, TIMER pad is used to set the Continuous Bake feature.

6.DELAY START PAD— Used to set the desired start time for baking & Self-Clean. May be used with COOK TIME to program a delayed bake or clean cycle.

7.UP ARROW PAD— Used along with the function pads to select oven temperature, cook time, start time (when programming an automatic start time), time of day, clean time and minute timer.

8.BAKE PAD—Used to select the bake function.

9.BROIL PAD— Used to select the variable broil function.

10.DOWN ARROW PAD— Used along with the function pads to select oven temperature, cook time, start time (when programming an automatic start time), time of day, clean time and minute timer.

11.STOP PAD— Used to clear any function previously entered except the time of day and minute timer. Press STOP to stop cooking. Also the STOP pad is used to activate oven lockout setting.

12.WARM PAD— Used to set the Warm & Hold feature.

13.OVEN, PREHEAT & DOOR LOCKED LIGHTS* — The “OVEN” light will glow each time the oven turns on to maintain the set oven temperature. The “PREHEAT” light will glow when the oven is first set to operate, or if the desired temperature is reset higher than the actual oven temperature. The “DOOR LOCKED” light will flash when the oven door locks and unlocks or when using the Self-Clean cycle or the oven door lockout is activated. The indicator light will glow constantly after the door locks.

*Note: The OVEN indicator light on the electronic display will turn ON and OFF when using the Bake feature and during preheat. This is normal and indicates that the oven is cycling to maintain the selected baking temperature. When the preheat indicator light turns OFF, your oven is ready.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Kenmore Table of Contents Important Safety Instructions Where appliance is in use. They should never While using the appliance. Do not let clothingWhen heating fat or grease, watch it closely Do not leave children alone-Children shouldSave These Safety Instructions Grounding Instructions Conversion to Liquefied Petroleum Gas or L.P. GasSlide-in Range Features Your Slide-in Range Features At a GlanceBefore Setting Surface Controls Control Locations of the Gas Surface BurnersSetting Surface Controls Setting Proper Surface Burner Flame SizeOperating the Gas Surface Controls Flame Size Type of CooktopUsing a wok Surface CookingUse Proper Cookware Before Setting Oven Controls Oven Vent LocationRemoving and Replacing Oven Racks Arranging Oven RacksSetting Oven Controls Control Pad FunctionsTo Set the Minute Timer Temperature conversionTo Change the Minute Timer while it is in use To Set the ClockTo Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingTo Set Control for Oven Lockout Cooking Information Oven BakingTo Set the Timed Bake and Delay Start Features When the Set Bake Time Runs OutSetting Oven Controls cont’d To Set for Broiling Broil Rack Position Table Refer to Fig Food categorySetting the Warm & Hold Feature To Operate the Oven LightTo set Warm & Hold To set Warm & Hold to turn on automaticallySelf-Cleaning Oven CleaningSelf-Clean Time Length Adjusting the Oven TemperatureTo Adjust Oven Temperature General Care & Cleaning Cleaning Various Parts of Your RangeGeneral Care & Cleaning cont’d Cleaning the Cooktop, Burner Heads, Caps & Grates3rd Removing and Replacing the Lift-Off Oven Door Door Hinge locations With oven door fully openTo Remove Oven Door To Replace Oven DoorChanging Oven Light Storage DrawerSolutions to Common Problems Appliance must be accessible forService Code error for exemple F11Self-cleaning cycle does not work Cleaning cyclePoor baking results Fan noise during cooking operationProtection Agreements Get it fixed, at your home or ours Cuisinière encastrable Emplacementdelaplaque de série Table des matièresGarantie sur appareil Kenmore Enregistrement de l’appareilEntretien par l’usager-Ne réparez pas ou ne Le faites, un empoisonnement au monoxyde deCarbone pourrait en résulter et l’appareil pourrait Ne modifiez jamais l’appareil, que ce soit enMesures de sécurité importantes Fours autonettoyants Ne laissez jamais les brûleurs sans surveillanceInstructions de mise à la terre Conversion au gaz propaneCaractéristiques de l’appareil Four autonettoyantAvant de régler les commandes des brûleurs de surface Emplacement des commandes des brûleurs de surfaceRéglage des commandes des brûleurs de surface Réglage de la bonne dimension de la flammeEmploi des brûleurs de surface Type de cuissonCuisson sur la table de cuisson Ustensiles pour la cuisson sur les brûleursUtilisation d’UN wok Avant de régler les commandes du four suite Installation des grillesPosition de l’évent Enlever et replacer les grilles de fourRéglage de la commande du four Fonctions des touches de la commande du fourPour un tableau de commande silencieux Réglage de lhorlogeRéglage de la minuterie Conversion de la températurePour régler la commande du four pour la cuisson au four Réglage de la fonction de verrouillage du fourPour régler la fonction de verrouillage Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Cuisson au gril Catégorie d’alimentRéglage de la fonction Garder ChaudMD Fonctionnement de la lampe du fourRéglage de la fonction Garder ChaudMD Cycle autonettoyant Nettoyage du fourPrenez les précautions de nettoyage qui suivent Préparation du four avant le cycle autonettoyantDurée du cycle autonettoyant Ajustement de la température du fourLa fin du cycle autonettoyant Arrêt ou interruption d’un cycle autonettoyantEntretien général & nettoyage Entretien général & nettoyage suite 1erNettoyage de l’acier inoxydable Enlever et replacer la porte du fourPour enlever la porte du four Pour replacer la porte du fourRemplacement de l’ampoule du four Tiroir de rangementSolutions aux problèmes les plus fréquents Facilement. Il doit être accessibleLa commande du four sonne et ’appareil n’est pas de niveauLa flamme est orange Le four dégage beaucoup de fuméeDurant la cuisson au gril Tion Réglage du four AutonettoyantContrats DE Protection Get it fixed, at your home or ours
Top Page Image Contents