Kenmore 318205869A manual Save These Safety Instructions

Page 5

Important Safety Instructions

•Do not use decorative surface burner covers. If a burner is accidentally turned on, the decorative cover will become hot and possibly melt. Burns will occur if the hot covers are touched. Damage may also be done to the cooktop or burners because the covers may cause overheating. Air will be blocked from the burner and cause combustion problems.

IMPORTANT INSTRUCTIONS FOR USING YOUR OVEN

•Use care when opening oven door or warmer drawer (if equipped)—Stand to the side of the range when opening the door of a hot oven. Let hot air or steam escape before you remove or replace food in the oven/ warmer drawer.

•Keep oven vent ducts unobstructed. The oven vent is located at the center rear of the cooktop. Touching the surfaces in this area when the oven is operating may cause severe burns. Also, do not place plastic or heat- sensitive items on or near the oven vent. These items could melt or ignite.

Never cover any slots, holes or passages in the oven bottom or cover an entire rack materials such as aluminum foil. Doing so blocks air flow through the oven and may cause carbon monoxide poisoning. Aluminum foil linings may trap heat, causing a fire hazard.

•Placement of oven/warmer drawer (if equipped) racks. Always place oven racks in desired location while oven/warmer drawer (if equipped) is cool. If rack must be moved while oven is hot use extreme caution. Use potholders and grasp the rack with both hands to reposition. Do not let potholders contact the hot heating elements in the oven/warmer drawer (if equipped). Remove all utensils from the rack before moving.

•Do not use the broiler pan without its insert.

The broiler pan and its insert allow dripping fat to drain and be kept away from the high heat of the broiler.

•Do not cover the broiler insert with aluminum foil. Exposed fat and grease could ignite.

•Do not touch a hot light bulb with a damp cloth. Doing so could cause the bulb to break.

Disconnect the appliance or turn off the power to the appliance before removing and replacing light bulb.

IMPORTANT INSTRUCTIONS FOR CLEANING YOUR RANGE

•Clean the range regularly to keep all parts free of grease that could catch fire. Exhaust fan ventilation hoods and grease filters should be kept clean. Do not allow grease to accumulate on hood or filter. Greasy deposits in the fan could catch fire. When you are flaming food under the hood, turn the fan on. Refer to the hood manufacturer’s instructions for cleaning.

SELF-CLEANING OVENS

•In the self-Cleaning cycle only clean the parts listed in this Use and Care Guide. Before self- cleaning the oven, remove the broiler pan and any utensils or foods from the oven.

•Do not use oven cleaners—No commercial oven cleaner or oven liner protective coating of any kind should be used in or around any part of the oven.

•Do not clean door gasket—The door gasket is essential for a good seal. Care should be taken not to rub, damage or move the gasket.

•Remove oven racks. Oven racks color will change if left in the oven during a self-cleaning cycle.

The health of some birds is extremely sensitive to the fumes given off during the self-cleaning cycle of the range. Move the birds to another well ventilated room.

Important Safety Notice

The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure to such substances.

SAVE THESE SAFETY INSTRUCTIONS

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Kenmore Table of Contents Important Safety Instructions While using the appliance. Do not let clothing Where appliance is in use. They should neverWhen heating fat or grease, watch it closely Do not leave children alone-Children shouldSave These Safety Instructions Conversion to Liquefied Petroleum Gas or L.P. Gas Grounding InstructionsYour Slide-in Range Features At a Glance Slide-in Range FeaturesControl Locations of the Gas Surface Burners Before Setting Surface ControlsSetting Proper Surface Burner Flame Size Setting Surface ControlsOperating the Gas Surface Controls Flame Size Type of CooktopUse Proper Cookware Using a wokSurface Cooking Oven Vent Location Before Setting Oven ControlsRemoving and Replacing Oven Racks Arranging Oven RacksControl Pad Functions Setting Oven ControlsTemperature conversion To Set the Minute TimerTo Change the Minute Timer while it is in use To Set the ClockTo Set Control for Oven Lockout To Set or Change the Temperature for BakingTo Set Control for Continuous Bake or 12 Hour Energy Saving Oven Baking Cooking InformationWhen the Set Bake Time Runs Out To Set the Timed Bake and Delay Start FeaturesBroil Rack Position Table Refer to Fig Food category Setting Oven Controls cont’d To Set for BroilingTo Operate the Oven Light Setting the Warm & Hold FeatureTo set Warm & Hold To set Warm & Hold to turn on automaticallyOven Cleaning Self-CleaningTo Adjust Oven Temperature Self-Clean Time LengthAdjusting the Oven Temperature Cleaning Various Parts of Your Range General Care & Cleaning3rd General Care & Cleaning cont’dCleaning the Cooktop, Burner Heads, Caps & Grates Door Hinge locations With oven door fully open Removing and Replacing the Lift-Off Oven DoorTo Remove Oven Door To Replace Oven DoorStorage Drawer Changing Oven LightAppliance must be accessible for Solutions to Common ProblemsService Code error for exemple F11Cleaning cycle Self-cleaning cycle does not workPoor baking results Fan noise during cooking operationProtection Agreements Get it fixed, at your home or ours Cuisinière encastrable Table des matières Emplacementdelaplaque de sérieGarantie sur appareil Kenmore Enregistrement de l’appareilLe faites, un empoisonnement au monoxyde de Entretien par l’usager-Ne réparez pas ou neCarbone pourrait en résulter et l’appareil pourrait Ne modifiez jamais l’appareil, que ce soit enMesures de sécurité importantes Ne laissez jamais les brûleurs sans surveillance Fours autonettoyantsConversion au gaz propane Instructions de mise à la terreFour autonettoyant Caractéristiques de l’appareilEmplacement des commandes des brûleurs de surface Avant de régler les commandes des brûleurs de surfaceRéglage de la bonne dimension de la flamme Réglage des commandes des brûleurs de surfaceEmploi des brûleurs de surface Type de cuissonUtilisation d’UN wok Cuisson sur la table de cuissonUstensiles pour la cuisson sur les brûleurs Installation des grilles Avant de régler les commandes du four suitePosition de l’évent Enlever et replacer les grilles de fourFonctions des touches de la commande du four Réglage de la commande du fourRéglage de lhorloge Pour un tableau de commande silencieuxRéglage de la minuterie Conversion de la températurePour régler la fonction de verrouillage Pour régler la commande du four pour la cuisson au fourRéglage de la fonction de verrouillage du four Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Catégorie d’aliment Cuisson au grilRéglage de la fonction Garder ChaudMD Réglage de la fonction Garder ChaudMDFonctionnement de la lampe du four Nettoyage du four Cycle autonettoyantPrenez les précautions de nettoyage qui suivent Préparation du four avant le cycle autonettoyantAjustement de la température du four Durée du cycle autonettoyantLa fin du cycle autonettoyant Arrêt ou interruption d’un cycle autonettoyantEntretien général & nettoyage 1er Entretien général & nettoyage suiteEnlever et replacer la porte du four Nettoyage de l’acier inoxydablePour enlever la porte du four Pour replacer la porte du fourTiroir de rangement Remplacement de l’ampoule du fourFacilement. Il doit être accessible Solutions aux problèmes les plus fréquentsLa commande du four sonne et ’appareil n’est pas de niveauLe four dégage beaucoup de fumée La flamme est orangeDurant la cuisson au gril Tion Réglage du four AutonettoyantContrats DE Protection Get it fixed, at your home or ours
Top Page Image Contents