Kenmore 318205869A manual General Care & Cleaning cont’d, 3rd

Page 22

General Care & Cleaning (cont’d)

Cleaning the Cooktop, Burner Heads, Caps & Grates

The cooktop is designed to make cleaning easier. Because the gas Burners are sealed, spillovers are easier to clean provided that they are cleaned up immediately.

The cooktop, Burner Heads and Caps should be routinely cleaned. Keeping the Burner Head Ports clean will prevent improper ignition and an uneven flame. Refer to the following instructions:

THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.

The fixed oven vent is not removable. Do not attempt to remove the fixed oven vent cover.

Use caution when replacing the Burner Caps so the Electrodes are not damaged. This may cause a delayed ignition or prevent the burner from igniting.

Any additions, changes or conversions required in order for this appliance to perform satisfactorily must be made by Sears Service. Call 1-800-4-MY-HOME®(See back cover).

Surface

1st

Burner

 

Grate

 

 

Surface

2nd

Burner

Cap

Surface

3rd

Burner

 

Head

Electrode

Orifice

holder

Figure 1

To Remove and Replace the Surface Burner Caps and Burner Heads - Remove in the following order: (1st) surface Burner Grates, (2nd) Burner Caps and (3rd) Burner Heads. Replace them in reverse order: Heads, Caps, then Grates.

Do not remove any parts from the cooktop until they have completely cooled and are safe to handle. Do not operate the surface Burners without the Burner Caps and Burner Heads properly in place.

To Clean the surface Burner Caps and Burner Heads- Use a soap-filled scouring pad or a mild abrasive cleanser to clean the surface Burner Caps and Burner Heads. The ports (or slots) around the Burner Heads must be routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle to clean the slots or holes. For proper flow of gas and ignition of the burner—DO NOT ALLOW

SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS keep the surface Burner Caps and Burner Heads in place whenever the gas Burners are in use.

To Clean the Burner Grates- The Burner Grates are dishwasher safe and may be cleaned in the dishwasher. Remove any excessive soils before placing in the dishwasher.

To Clean the Cooktop and contoured areas of the cooktop- If a spill occurs on the porcelain cooktop, blot up spill with an absorbent cloth. Rinse with a clean, damp cloth and wipe dry. Do not use harsh abrasive cleaners on the cooktop. They can scratch the porcelain. Completely rinse any mild cleaners used from the surface or the porcelain cooktop may become damaged during future heating. DO NOT use spray oven cleaners on the cooktop.

22

Image 22
Contents Kenmore Table of Contents Important Safety Instructions When heating fat or grease, watch it closely Where appliance is in use. They should neverWhile using the appliance. Do not let clothing Do not leave children alone-Children shouldSave These Safety Instructions Grounding Instructions Conversion to Liquefied Petroleum Gas or L.P. GasSlide-in Range Features Your Slide-in Range Features At a GlanceBefore Setting Surface Controls Control Locations of the Gas Surface BurnersOperating the Gas Surface Controls Setting Surface ControlsSetting Proper Surface Burner Flame Size Flame Size Type of CooktopSurface Cooking Using a wokUse Proper Cookware Removing and Replacing Oven Racks Before Setting Oven ControlsOven Vent Location Arranging Oven RacksSetting Oven Controls Control Pad FunctionsTo Change the Minute Timer while it is in use To Set the Minute TimerTemperature conversion To Set the ClockTo Set Control for Continuous Bake or 12 Hour Energy Saving To Set or Change the Temperature for BakingTo Set Control for Oven Lockout Cooking Information Oven BakingTo Set the Timed Bake and Delay Start Features When the Set Bake Time Runs OutSetting Oven Controls cont’d To Set for Broiling Broil Rack Position Table Refer to Fig Food categoryTo set Warm & Hold Setting the Warm & Hold FeatureTo Operate the Oven Light To set Warm & Hold to turn on automaticallySelf-Cleaning Oven CleaningAdjusting the Oven Temperature Self-Clean Time LengthTo Adjust Oven Temperature General Care & Cleaning Cleaning Various Parts of Your RangeCleaning the Cooktop, Burner Heads, Caps & Grates General Care & Cleaning cont’d3rd To Remove Oven Door Removing and Replacing the Lift-Off Oven DoorDoor Hinge locations With oven door fully open To Replace Oven DoorChanging Oven Light Storage DrawerService Solutions to Common ProblemsAppliance must be accessible for Code error for exemple F11Poor baking results Self-cleaning cycle does not workCleaning cycle Fan noise during cooking operationProtection Agreements Get it fixed, at your home or ours Cuisinière encastrable Garantie sur appareil Kenmore Emplacementdelaplaque de sérieTable des matières Enregistrement de l’appareilCarbone pourrait en résulter et l’appareil pourrait Entretien par l’usager-Ne réparez pas ou neLe faites, un empoisonnement au monoxyde de Ne modifiez jamais l’appareil, que ce soit enMesures de sécurité importantes Fours autonettoyants Ne laissez jamais les brûleurs sans surveillanceInstructions de mise à la terre Conversion au gaz propaneCaractéristiques de l’appareil Four autonettoyantAvant de régler les commandes des brûleurs de surface Emplacement des commandes des brûleurs de surfaceEmploi des brûleurs de surface Réglage des commandes des brûleurs de surfaceRéglage de la bonne dimension de la flamme Type de cuissonUstensiles pour la cuisson sur les brûleurs Cuisson sur la table de cuissonUtilisation d’UN wok Position de l’évent Avant de régler les commandes du four suiteInstallation des grilles Enlever et replacer les grilles de fourRéglage de la commande du four Fonctions des touches de la commande du fourRéglage de la minuterie Pour un tableau de commande silencieuxRéglage de lhorloge Conversion de la températureRéglage de la fonction de verrouillage du four Pour régler la commande du four pour la cuisson au fourPour régler la fonction de verrouillage Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Cuisson au gril Catégorie d’alimentFonctionnement de la lampe du four Réglage de la fonction Garder ChaudMDRéglage de la fonction Garder ChaudMD Prenez les précautions de nettoyage qui suivent Cycle autonettoyantNettoyage du four Préparation du four avant le cycle autonettoyantLa fin du cycle autonettoyant Durée du cycle autonettoyantAjustement de la température du four Arrêt ou interruption d’un cycle autonettoyantEntretien général & nettoyage Entretien général & nettoyage suite 1erPour enlever la porte du four Nettoyage de l’acier inoxydableEnlever et replacer la porte du four Pour replacer la porte du fourRemplacement de l’ampoule du four Tiroir de rangementLa commande du four sonne et Solutions aux problèmes les plus fréquentsFacilement. Il doit être accessible ’appareil n’est pas de niveauDurant la cuisson au gril Tion Réglage du four La flamme est orangeLe four dégage beaucoup de fumée AutonettoyantContrats DE Protection Get it fixed, at your home or ours