Kenmore 318205869A manual Cooking Information, Oven Baking

Page 15

Cooking Information

Oven Baking

For best cooking results, heat the oven before baking cookies, breads, cakes, pies or pastries, etc... There is no need to preheat the oven for roasting meat or baking casseroles.

The cooking times and temperatures needed to bake a product may vary slightly from your previously owned appliance.

Baking Problems and Solutions Chart

Baking Problems	Causes		Corrections
Cookies and bis-	•	Cookies and biscuits put into the	• Allow oven to preheat to the selected temperature before
cuits burn on the		oven before the preheating time	placing food in oven.
bottom.		is completed.
	•	Oven rack overcrowded.	• Choose pan sizes that will permit 5.1 cm to 10.2 cm (2” to
			4”) of air space on all sides when placed in the oven.
	• Dark pan absorbs heat too fast.		• Use a medium-weight aluminum baking sheet.

Cakes too dark on	•	Cakes put into the oven before	• Allow oven to preheat to the selected temperature before
top or bottom.		preheating time is completed.	placing food in the oven.

	• Rack position too high or low.		• Use proper rack position for baking needs.
	•	Oven too hot.	• Set oven temperature 25°F/12°C lower than
			recommended.
Cakes not done in	•	Oven too hot.	• Set oven temperature 25°F/12°C lower than
the center.			recommended.

	•	Incorrect pan size.	• Use pan size suggested in recipe.
	• Pan not centered in oven.		• Use proper rack position and place pan so there is 5.1 cm
			to 10.2 cm (2” to 4”) of space on all sides of pan.

Cakes not level.	•	Range not level.	• Place a marked glass measuring cup filled with water on
			the center of the oven rack. If the water level is uneven,
			refer to the installation instructions for levelling the range.
	• Pan too close to oven wall or		• Be sure to allow 5.1 cm to 10.2 cm (2” to 4”) of clearance
		rack overcrowded.	on all sides of each pan in the oven.

	•	Pan warped.	• Do not use pans that are dented or warped.
Foods not done	•	Oven too cool.	• Set oven temperature 25°F/12°C higher than suggested
when cooking time			and bake for the recommended time.
is up.	•	Oven overcrowded.	• Be sure to remove all pans from the oven except the ones
	•	Oven overcrowded.	• Be sure to remove all pans from the oven except the ones
			to be used for baking.
	• Oven door opened too		• Open oven door only after shortest recommended baking
		frequently.	time.

15

Image 15

Contents Kenmore Table of Contents Important Safety Instructions Do not leave children alone-Children should Where appliance is in use. They should neverWhile using the appliance. Do not let clothing When heating fat or grease, watch it closelySave These Safety Instructions Conversion to Liquefied Petroleum Gas or L.P. Gas Grounding InstructionsYour Slide-in Range Features At a Glance Slide-in Range FeaturesControl Locations of the Gas Surface Burners Before Setting Surface ControlsFlame Size Type of Cooktop Setting Surface ControlsSetting Proper Surface Burner Flame Size Operating the Gas Surface ControlsUsing a wok Surface CookingUse Proper Cookware Arranging Oven Racks Before Setting Oven ControlsOven Vent Location Removing and Replacing Oven RacksControl Pad Functions Setting Oven ControlsTo Set the Clock To Set the Minute TimerTemperature conversion To Change the Minute Timer while it is in useTo Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingTo Set Control for Oven Lockout Oven Baking Cooking InformationWhen the Set Bake Time Runs Out To Set the Timed Bake and Delay Start FeaturesBroil Rack Position Table Refer to Fig Food category Setting Oven Controls cont’d To Set for BroilingTo set Warm & Hold to turn on automatically Setting the Warm & Hold FeatureTo Operate the Oven Light To set Warm & HoldOven Cleaning Self-CleaningSelf-Clean Time Length Adjusting the Oven TemperatureTo Adjust Oven Temperature Cleaning Various Parts of Your Range General Care & CleaningGeneral Care & Cleaning cont’d Cleaning the Cooktop, Burner Heads, Caps & Grates3rd To Replace Oven Door Removing and Replacing the Lift-Off Oven DoorDoor Hinge locations With oven door fully open To Remove Oven DoorStorage Drawer Changing Oven LightCode error for exemple F11 Solutions to Common ProblemsAppliance must be accessible for ServiceFan noise during cooking operation Self-cleaning cycle does not workCleaning cycle Poor baking resultsProtection Agreements Get it fixed, at your home or ours Cuisinière encastrable Enregistrement de l’appareil Emplacementdelaplaque de sérieTable des matières Garantie sur appareil KenmoreNe modifiez jamais l’appareil, que ce soit en Entretien par l’usager-Ne réparez pas ou neLe faites, un empoisonnement au monoxyde de Carbone pourrait en résulter et l’appareil pourraitMesures de sécurité importantes Ne laissez jamais les brûleurs sans surveillance Fours autonettoyantsConversion au gaz propane Instructions de mise à la terreFour autonettoyant Caractéristiques de l’appareilEmplacement des commandes des brûleurs de surface Avant de régler les commandes des brûleurs de surfaceType de cuisson Réglage des commandes des brûleurs de surfaceRéglage de la bonne dimension de la flamme Emploi des brûleurs de surfaceCuisson sur la table de cuisson Ustensiles pour la cuisson sur les brûleursUtilisation d’UN wok Enlever et replacer les grilles de four Avant de régler les commandes du four suiteInstallation des grilles Position de l’éventFonctions des touches de la commande du four Réglage de la commande du fourConversion de la température Pour un tableau de commande silencieuxRéglage de lhorloge Réglage de la minuteriePour régler la commande du four pour la cuisson au four Réglage de la fonction de verrouillage du fourPour régler la fonction de verrouillage Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Catégorie d’aliment Cuisson au grilRéglage de la fonction Garder ChaudMD Fonctionnement de la lampe du fourRéglage de la fonction Garder ChaudMD Préparation du four avant le cycle autonettoyant Cycle autonettoyantNettoyage du four Prenez les précautions de nettoyage qui suiventArrêt ou interruption d’un cycle autonettoyant Durée du cycle autonettoyantAjustement de la température du four La fin du cycle autonettoyantEntretien général & nettoyage 1er Entretien général & nettoyage suitePour replacer la porte du four Nettoyage de l’acier inoxydableEnlever et replacer la porte du four Pour enlever la porte du fourTiroir de rangement Remplacement de l’ampoule du four’appareil n’est pas de niveau Solutions aux problèmes les plus fréquentsFacilement. Il doit être accessible La commande du four sonne etAutonettoyant La flamme est orangeLe four dégage beaucoup de fumée Durant la cuisson au gril Tion Réglage du fourContrats DE Protection Get it fixed, at your home or ours