Kenmore 318205869A manual Changing Oven Light, Storage Drawer

Page 24

General Care & Cleaning (cont’d)

Changing Oven Light

Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during the self-cleaning cycle. High temperature will reduce lamp life.

On some models an interior oven light will turn on automatically when the oven door is opened.

The oven light may be turned on when the door is closed by pressing the pad on the control panel. On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.

THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.

To replace the light bulb:

CAUTION: BE SURE OVEN IS COOL

1. Turn the power off at the main source.

2. Wear a leather-faced glove for protection against possible broken glass. 3. Replace bulb with a 40 watt appliance bulb only.

4.For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.

Storage Drawer

Use the storage drawer for storing cooking utensils. The drawer can de removed to facilitate cleaning under the range. Use care when handling the drawer.

Removing and Replacing Storage Drawer

To remove the drawer:

1.Pull empty drawer out to the roller guide stop.

2.Tilt the drawer up and pull it out over the rollers.

To replace the drawer:

1.Insert the rear end of the drawer into the opening.

2.Fit the drawer end rollers onto the guide rails.

3.Push the drawer in until it stops, then lift to allow the rollers to clear the roller guide stop, and push in.

Roller Storage

Drawer

Roller

Guide

Front Frame

24

Image 24

Contents Kenmore Table of Contents Important Safety Instructions Where appliance is in use. They should never While using the appliance. Do not let clothingWhen heating fat or grease, watch it closely Do not leave children alone-Children shouldSave These Safety Instructions Grounding Instructions Conversion to Liquefied Petroleum Gas or L.P. GasSlide-in Range Features Your Slide-in Range Features At a GlanceBefore Setting Surface Controls Control Locations of the Gas Surface BurnersSetting Surface Controls Setting Proper Surface Burner Flame SizeOperating the Gas Surface Controls Flame Size Type of CooktopUsing a wok Surface CookingUse Proper Cookware Before Setting Oven Controls Oven Vent LocationRemoving and Replacing Oven Racks Arranging Oven RacksSetting Oven Controls Control Pad FunctionsTo Set the Minute Timer Temperature conversionTo Change the Minute Timer while it is in use To Set the ClockTo Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingTo Set Control for Oven Lockout Cooking Information Oven BakingTo Set the Timed Bake and Delay Start Features When the Set Bake Time Runs OutSetting Oven Controls cont’d To Set for Broiling Broil Rack Position Table Refer to Fig Food categorySetting the Warm & Hold Feature To Operate the Oven LightTo set Warm & Hold To set Warm & Hold to turn on automaticallySelf-Cleaning Oven CleaningSelf-Clean Time Length Adjusting the Oven TemperatureTo Adjust Oven Temperature General Care & Cleaning Cleaning Various Parts of Your RangeGeneral Care & Cleaning cont’d Cleaning the Cooktop, Burner Heads, Caps & Grates3rd Removing and Replacing the Lift-Off Oven Door Door Hinge locations With oven door fully openTo Remove Oven Door To Replace Oven DoorChanging Oven Light Storage DrawerSolutions to Common Problems Appliance must be accessible forService Code error for exemple F11Self-cleaning cycle does not work Cleaning cyclePoor baking results Fan noise during cooking operationProtection Agreements Get it fixed, at your home or ours Cuisinière encastrable Emplacementdelaplaque de série Table des matièresGarantie sur appareil Kenmore Enregistrement de l’appareilEntretien par l’usager-Ne réparez pas ou ne Le faites, un empoisonnement au monoxyde deCarbone pourrait en résulter et l’appareil pourrait Ne modifiez jamais l’appareil, que ce soit enMesures de sécurité importantes Fours autonettoyants Ne laissez jamais les brûleurs sans surveillanceInstructions de mise à la terre Conversion au gaz propaneCaractéristiques de l’appareil Four autonettoyantAvant de régler les commandes des brûleurs de surface Emplacement des commandes des brûleurs de surfaceRéglage des commandes des brûleurs de surface Réglage de la bonne dimension de la flammeEmploi des brûleurs de surface Type de cuissonCuisson sur la table de cuisson Ustensiles pour la cuisson sur les brûleursUtilisation d’UN wok Avant de régler les commandes du four suite Installation des grillesPosition de l’évent Enlever et replacer les grilles de fourRéglage de la commande du four Fonctions des touches de la commande du fourPour un tableau de commande silencieux Réglage de lhorlogeRéglage de la minuterie Conversion de la températurePour régler la commande du four pour la cuisson au four Réglage de la fonction de verrouillage du fourPour régler la fonction de verrouillage Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Cuisson au gril Catégorie d’alimentRéglage de la fonction Garder ChaudMD Fonctionnement de la lampe du fourRéglage de la fonction Garder ChaudMD Cycle autonettoyant Nettoyage du fourPrenez les précautions de nettoyage qui suivent Préparation du four avant le cycle autonettoyantDurée du cycle autonettoyant Ajustement de la température du fourLa fin du cycle autonettoyant Arrêt ou interruption d’un cycle autonettoyantEntretien général & nettoyage Entretien général & nettoyage suite 1erNettoyage de l’acier inoxydable Enlever et replacer la porte du fourPour enlever la porte du four Pour replacer la porte du fourRemplacement de l’ampoule du four Tiroir de rangementSolutions aux problèmes les plus fréquents Facilement. Il doit être accessibleLa commande du four sonne et ’appareil n’est pas de niveauLa flamme est orange Le four dégage beaucoup de fuméeDurant la cuisson au gril Tion Réglage du four AutonettoyantContrats DE Protection Get it fixed, at your home or ours