Kenmore 318205869A To Set or Change the Temperature for Baking, To Set Control for Oven Lockout

Page 14

Setting Oven Controls

To Set or Change the Temperature for Baking

The oven can be programmed to bake at any temperature from 170°F to 550°F (77°C to 287°C).

To Set the Controls for Baking:

1.Press . "— — —°" appears in the display.

2.Within 5 seconds, press the or . The display will show "350°F (177°C)." By pressing and holding the or , the temperature can then be adjusted in 5°F increments (1°C).

3.As soon as the or pad is released, the oven will begin heating to the selected temperature. When the displayed temperature reaches the desired baking temperature, the preheat indicator light will turn OFF and the control will beep 3 times.

4.To cancel baking, press .

To Change the Oven Temperature after Baking has Started:

1.Press and make sure the bake temperature is displayed.

2.Press the or pad to increase or decrease the set temperature.

To Set Control for Continuous Bake or 12 Hour Energy Saving

The oven control has a built-in 12 Hour Energy Saving feature that will shut off the oven if the control is left on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for continuous baking.

To set control for continuous baking:

1.Press and hold down for 5 seconds until tone is heard, " — — hr" will appear in display for continuous cooking. The current time of day will return to the display.

2.To cancel the Continuous Bake function, press and hold for 5 seconds until tone is heard. "12hr" will appear in display indicating that the control has returned to the 12 Hour Energy Saving feature.

To Set Control for Oven Lockout

The control can be programmed to lock the oven control pads and lock the oven door

To set the Lockout feature:

1.Press and hold for 3 seconds. “Loc” will appear in display, the “Door Locked” indicator light will flash and the motordriven door lock will begin to close automatically. DO NOT open oven door while the indicator light is flashing. Allow about 15 seconds for the oven door to lock. Once the oven door is locked, the current time of day will appear in the display.

2.To cancel the Lockout feature, press and hold for 3 seconds. Self-Cleaning Oven models: The control will unlock the oven door and resume normal operation.

Note: If any control pad is pressed while in the Oven Lockout mode, “Loc” will appear in the display until the control pad is released.

14

Image 14

Contents Kenmore Table of Contents Important Safety Instructions When heating fat or grease, watch it closely Where appliance is in use. They should neverWhile using the appliance. Do not let clothing Do not leave children alone-Children shouldSave These Safety Instructions Grounding Instructions Conversion to Liquefied Petroleum Gas or L.P. GasSlide-in Range Features Your Slide-in Range Features At a GlanceBefore Setting Surface Controls Control Locations of the Gas Surface BurnersOperating the Gas Surface Controls Setting Surface ControlsSetting Proper Surface Burner Flame Size Flame Size Type of CooktopUse Proper Cookware Using a wokSurface Cooking Removing and Replacing Oven Racks Before Setting Oven ControlsOven Vent Location Arranging Oven RacksSetting Oven Controls Control Pad FunctionsTo Change the Minute Timer while it is in use To Set the Minute TimerTemperature conversion To Set the ClockTo Set Control for Oven Lockout To Set or Change the Temperature for BakingTo Set Control for Continuous Bake or 12 Hour Energy Saving Cooking Information Oven BakingTo Set the Timed Bake and Delay Start Features When the Set Bake Time Runs OutSetting Oven Controls cont’d To Set for Broiling Broil Rack Position Table Refer to Fig Food categoryTo set Warm & Hold Setting the Warm & Hold FeatureTo Operate the Oven Light To set Warm & Hold to turn on automaticallySelf-Cleaning Oven CleaningTo Adjust Oven Temperature Self-Clean Time LengthAdjusting the Oven Temperature General Care & Cleaning Cleaning Various Parts of Your Range3rd General Care & Cleaning cont’dCleaning the Cooktop, Burner Heads, Caps & Grates To Remove Oven Door Removing and Replacing the Lift-Off Oven DoorDoor Hinge locations With oven door fully open To Replace Oven DoorChanging Oven Light Storage DrawerService Solutions to Common ProblemsAppliance must be accessible for Code error for exemple F11Poor baking results Self-cleaning cycle does not workCleaning cycle Fan noise during cooking operationProtection Agreements Get it fixed, at your home or ours Cuisinière encastrable Garantie sur appareil Kenmore Emplacementdelaplaque de sérieTable des matières Enregistrement de l’appareilCarbone pourrait en résulter et l’appareil pourrait Entretien par l’usager-Ne réparez pas ou neLe faites, un empoisonnement au monoxyde de Ne modifiez jamais l’appareil, que ce soit enMesures de sécurité importantes Fours autonettoyants Ne laissez jamais les brûleurs sans surveillanceInstructions de mise à la terre Conversion au gaz propaneCaractéristiques de l’appareil Four autonettoyantAvant de régler les commandes des brûleurs de surface Emplacement des commandes des brûleurs de surfaceEmploi des brûleurs de surface Réglage des commandes des brûleurs de surfaceRéglage de la bonne dimension de la flamme Type de cuissonUtilisation d’UN wok Cuisson sur la table de cuissonUstensiles pour la cuisson sur les brûleurs Position de l’évent Avant de régler les commandes du four suiteInstallation des grilles Enlever et replacer les grilles de fourRéglage de la commande du four Fonctions des touches de la commande du fourRéglage de la minuterie Pour un tableau de commande silencieuxRéglage de lhorloge Conversion de la températurePour régler la fonction de verrouillage Pour régler la commande du four pour la cuisson au fourRéglage de la fonction de verrouillage du four Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Cuisson au gril Catégorie d’alimentRéglage de la fonction Garder ChaudMD Réglage de la fonction Garder ChaudMDFonctionnement de la lampe du four Prenez les précautions de nettoyage qui suivent Cycle autonettoyantNettoyage du four Préparation du four avant le cycle autonettoyantLa fin du cycle autonettoyant Durée du cycle autonettoyantAjustement de la température du four Arrêt ou interruption d’un cycle autonettoyantEntretien général & nettoyage Entretien général & nettoyage suite 1erPour enlever la porte du four Nettoyage de l’acier inoxydableEnlever et replacer la porte du four Pour replacer la porte du fourRemplacement de l’ampoule du four Tiroir de rangementLa commande du four sonne et Solutions aux problèmes les plus fréquentsFacilement. Il doit être accessible ’appareil n’est pas de niveauDurant la cuisson au gril Tion Réglage du four La flamme est orangeLe four dégage beaucoup de fumée AutonettoyantContrats DE Protection Get it fixed, at your home or ours