3.Seat cups by placing a drift or socket (slightly smaller than the cup) on cup and rap with a hammer. See Figure 31. Install snap ring and repeat on opposite cup
4.Repeat Step 1 and Step 2 to install remaining cups in remaining yoke.
5.Move both yokes in all directions to check for free movement. If movement is restricted, rap on yokes sharply with a hammer to relieve any tension. Repeat until both yokes move in all directions without restriction.
Do not attempt to mount a tire unless you have the proper equipment and experience to perform the job.
Always maintain the correct tire pressure. Do not inflate tires above the recommended pressure. Never weld or heat a wheel and tire assembly. The heat can cause an increase in air pressure and result in a tire explosion. Welding can structurally weaken or deform the wheel.
When inflating tires, use a
—not in front of or over the tire assembly. Use a safety cage if available.
Check wheels for low pressure, cuts, bubbles, dam- aged rims, or missing lug bolts and nuts.
Never remove split rim assembly hardware (A) with the tire inflated.
Figure 31. Install Cups
SERVICING TIRES SAFELY
Used Aircraft Tires (Figure 32)
WARNING
A
DECAL PN 1006348
Figure 32. Split Rim Tire Servicing
36 Dealer Service
(Rev. 5/11/2007) MAN0390 (Rev. 4/6/2007)