Woods Equipment DS120 manual Install Hydraulic Hose, DS96 Pull-Type Rear Half Installation

Install Hydraulic Hose

On pull-type units with optional hydraulic cut- ting height adjustment, use a single-acting cylinder with a maximum extended length of 28-1/4" (718 mm) from attaching point center to center.

NOTICE

■If using a cylinder other than the one supplied by Woods, make sure a breather fitting is installed

in the cylinder rod end port. Use a restricter fitting in the base end port to dampen the cutter lowering action.

1.Install reducer bushing (9) and restricter swivel elbow (10) in port at base end of cylinder (8). Position elbow to point toward front of cutter.

NOTE: Make sure there is a breather fitting installed in the rod end port.

2.Connect hose (11) to elbow (10).

3.Install optional stroke control kit (14) to cylinder rod. Stroke control kit is used to set cut height.

1.	Tailwheel	7.	Transport lock-up	16.	Headless pin, 1 x 4
2.	Wheel hub	8.	Hydraulic cylinder	30.	Wheel bolt, 1/2 NF x 1-1/8
3.	15" Steel rim	9.	Reducer	31.	Cap screw, 1/2 NF x 1
4.	21" Solid tire -or-	10.	Elbow, restricter	32.	Lock washer, 1/2
4.	22" Aircraft tire -or-	11.	Hose, 156"	33.	Cap screw, 1/2 NC x 3
4.	29" Aircraft tire	12.	Ratchet	34.	Flange lock nut, 1/2 NC
5.	Attitude rod	13.	Clevis pin, 1.0 x 2.26	35.	Cotter pin, 1/4 x 1-1/2
6.	Spacer	14.	Stroke control kit	36.	Hex nut, 1 NC
		15.	Headless pin, 1 x 4-1/2	37.	Flat washer, 1"

Figure 33. DS96 Pull-Type Rear Half Installation

38 Assembly MAN0390 (Rev. 4/6/2007)