Shindaiwa DG150MI Gauges, Fluid Level Monitoring Lamp DG250MI only, Tachometer DG250MI only

Page 12

When the battery fluid level is low, Battery Fluid Monitoring Lamp will flash.

If the lamp is flashing, quickly add some distilled water. (refer to 8.6 Checking Battery)

5.1.6Fluid Level Monitoring Lamp [DG250MI only]

!Caution

:Fire

￿This equipment uses Diesel fuel as a fuel. When refueling, always stop the engine, and keep away from fire. Moreover, always wait until the engine cools down before refueling.

￿Always wipe any drip of Diesel fuel or oil. Do not use this equipment when a leak is found. Repair the equipment before use.

When the fuel level reaches less than 1/4 tank, Fluid Level Monitoring Lamp will flash. If the lamp is flashing, add fuel.

<Caution>

Just after the engine started, lamp will not flash promptly even in the event of 1/4 tank level fuel, which is not malfanction.

5.2 Gauges

5.2.1 Tachometer [DG250MI only]

Tachometer displays the revolution of engine and the generator.

The frequency of the generator is 50Hz at 1500min-1and 60Hz at 1800min-1.

5.2.2 Hour Meter

Hour Meter keeps track of utilization time. Use this meter to schedule your Preventative Maintenance. Note that the Hour Meter will operate, as long as the start switch is in ON position, regardless of whether the engine is perating or stopped.

<Caution>

DG250MI incorporates Hour Meter in Tachometer.

- 12 -

Image 12
Contents Table of Contents DG150MI DG250MIIntroduction Safety Guidelines Suffocation from exhaust fumeElectrical Shock InjuriesInjuries to eyes and skin FireBurns Location of Warning labels Specifications Specification MatrixAlternator Engine Control Panel Unit Name of GeneratorParts Ambient ConditionExternal view Control panel NameWater Temperature Monitoring Lamp for temperature High EquipmentMonitor Display Engine Oil Monitoring Lamp for oil pressure low Battery Charge Monitoring Lamp charge lamp Gauges Fluid Level Monitoring Lamp DG250MI onlyTachometer DG250MI only Hour MeterWater Temperature Gauge DG250MI only Oil Pressure Gauge DG250MI onlyGenerator Gauges LampSwitch Fuel Line Changeover Valve 3-way valve Voltage Regulator and Throttle HandleVoltage Regulator Throttle HandleTransport and Installation Using fuel from built-in fuel tankUsing fuel from external fuel tank TransportationInstallation TransportationConnection Selecting CableElectrical damages Connecting Cable Load Connection Terminal Plate 3-Phase / 1-phase 2 1-Phase Output Terminals & Receptacles 2.1 2002.2 400 Earth Leakage Relay and Grounding Grounding WorkOperation Check Earth leakage breaker relay has activatedInitialization and pre-check Checking Engine OilElectrical Shock Injuries Fire BurnsViscosity and temperature Checking Coolant / WaterEngine Oil Capacity Checking Radiator / Adding water Checking Coolant reservoir tank / Adding coolantChecking Fan Belt Coolant CapacityTension ConditionChecking Fuel Checking Battery Replacing the batteryChecking Fuel, Engine Oil, and Water leakage Operation Initializing / preparationDuring Operation Post startup checkStopping the Generator Protection⑥ Features Adjustment During operationConnecting to External Fuel Tank Protection Feature ListOverload Maintenance Turn the lever for 3-way valve to B positionGenerator side Oil Change Oil Filter ChangeModel Isuzu Part No Cleaning / Changing Air Filter Element Cleaning / Changing Fuel FilterDraining Water from Fuel Tank Changing Coolant / WaterModel Storage Procedures Long-term StorageTroubleshooting StackingSymptoms Possible Cause Corrective Actions Generator Wiring Diagram Page Page Page Engine Wiring Diagram