Shindaiwa DG150MI, DG250MI specifications Oil Change, Oil Filter Change, Model Isuzu Part No

10.1 Oil Change

	First time				50 hour mark
	From second time				Every 200 hours
		Remove Oil Filler cap
②		Loosen the engine oil drain plug and allow the oil
		to drain fully
③		Reinstall the drain plug
		Add oil from oil filler and fill up to the MAX level.
④
		You should check the oil level on the dipstick
①
		Reinstall the filler cap hand-tight
⑤
<Caution>
For the types of engine oil to use and volume to replace, refer to <8-1 Checking Engine Oil>
10.2 Oil Filter Change
	First time				50 hour mark
	From second time				Every 400 hours
		Drain the engine oil fully, as described in 10.1
②		Loosen and remove the oil filter, using an oil filter wrench
		Smear a little engine oil on the rubber gasket of the new oil filter
③
		Screw the new filter into place and tighten it by hand until the
①
		gasket contacts the seat. Then, give it additional 2/3 turn to seat
		the filter, using an oil filter wrench
		Add oil and install filler cap
⑤
<Caution>
￿		If an oil filter wrench is not available, contact our authorized
④		distributor or our engineering section..
￿		Oil filter:
				Model		ISUZU Part No.
			DG150MI			8944567412
			DG250MI			8944567411

- 36 -