Shindaiwa DG250MI, DG150MI Battery Charge Monitoring Lamp charge lamp, Injuries to eyes and skin

Page 11

5.1.3 Battery Charge Monitoring Lamp (charge lamp)

When the battery is unable to be charged during operation, the battery charge-monitoring lamp will flash.

Check the belt for damages or cut, and replace if needed.

<Caution>

￿For changing the belt, refer to the User Manual for Engine.

￿Battery Charge Monitor cannot detect the degradation of battery life nor the battery fluid level (refer to 8-6 Checking Battery)

5.1.4Air Filter Monitoring Lamp (clogged filter element) [DG250MI only]

!Danger

:Injuries

￿Close all doors and place locks during operating this equipment, to avoid injuries by unintentionally touching cooling fan and fan belt.

!Caution

:Burns

￿Do not touch the engine and muffler during operation and immediately after stopping the equipment, for the temperature can reach extremely high.

When the air filter element becomes dirty or clogged, the air filter monitoring lamp will flash. Turn off the engine and clean the filter element or replace if needed.

(refer to 10. Maintenance)

5.1.5Battery Fluid Monitoring Lamp (insufficient battery fluid) [DG250MI only]

!Caution

:Injuries to eyes and skin

￿Battery fluid contains diluted sulfuric acid. Avoid contact with eyes, skin or on clothing. If the acid comes in contact, especially with eyes, flush with a lot of water, and contact your physician immediately.

!Caution

:Fire

￿Battery may emit some combustible gas, so keep it away from fire and sparks.

- 11 -

Image 11
Contents DG150MI DG250MI Table of ContentsIntroduction Injuries Safety GuidelinesSuffocation from exhaust fume Electrical ShockBurns Injuries to eyes and skinFire Location of Warning labels Control Panel Unit Name of Generator SpecificationsSpecification Matrix Alternator EngineExternal view PartsAmbient Condition Name Control panelMonitor Display Water Temperature Monitoring Lamp for temperature HighEquipment Engine Oil Monitoring Lamp for oil pressure low Battery Charge Monitoring Lamp charge lamp Hour Meter GaugesFluid Level Monitoring Lamp DG250MI only Tachometer DG250MI onlyLamp Water Temperature Gauge DG250MI onlyOil Pressure Gauge DG250MI only Generator GaugesSwitch Throttle Handle Fuel Line Changeover Valve 3-way valveVoltage Regulator and Throttle Handle Voltage RegulatorTransportation Transport and InstallationUsing fuel from built-in fuel tank Using fuel from external fuel tankTransportation InstallationElectrical damages ConnectionSelecting Cable Connecting Cable Load Connection Terminal Plate 3-Phase / 1-phase 2.2 400 2 1-Phase Output Terminals & Receptacles2.1 200 Grounding Work Earth Leakage Relay and GroundingEarth leakage breaker relay has activated Operation CheckFire Burns Initialization and pre-checkChecking Engine Oil Electrical Shock InjuriesEngine Oil Capacity Viscosity and temperatureChecking Coolant / Water Checking Coolant reservoir tank / Adding coolant Checking Radiator / Adding waterCondition Checking Fan BeltCoolant Capacity TensionChecking Fuel Checking Fuel, Engine Oil, and Water leakage Checking BatteryReplacing the battery Initializing / preparation OperationPost startup check During OperationAdjustment During operation Stopping the Generator Protection⑥ FeaturesOverload Connecting to External Fuel TankProtection Feature List Turn the lever for 3-way valve to B position MaintenanceGenerator side Model Isuzu Part No Oil ChangeOil Filter Change Cleaning / Changing Fuel Filter Cleaning / Changing Air Filter ElementModel Draining Water from Fuel TankChanging Coolant / Water Long-term Storage Storage ProceduresStacking TroubleshootingSymptoms Possible Cause Corrective Actions Generator Wiring Diagram Page Page Page Engine Wiring Diagram