Shindaiwa DG250MI, DG150MI specifications Connecting Cable, Electrical Shock

Page 19

Selection of cable

■	(Example) 220V and Voltage Drop 11V
	3-Phase 3-Wire Cap Tire Cable, Single Core
		Length
		Length	50m or	75m		100m
		Current	below
		Current
		20A	3.5	5.5		8
		40A	8	14		14
		60A	14	14		22

		80A	14	22		22

(Example) 100V and Voltage Drop 5V

1-Phase 2-Wire Cap Tire Cable, Single Core

			(Unit: mm2)

Length	50m or	75m	100m
Current	below
Current
10A	5.5	5.5	8

20A	8	14	22

30A	14	22	22

125m	150m
8	14
14	22
22	30
30	38

(Unit: mm2)

200m

14

22

38

50

7.2Connecting Cable

!Danger

:Electrical Shock

Before connecting or disconnecting a load cable from output terminals, always turn a circuit breaker to OFF position, stop the engine, and remove the engine key. A person performing the maintenance should always keep the key.

! Caution

:Fire

Do not connect AC output to any indoor wiring.

<Caution>

Divide loads into 3 circuits proportionally as possible, when using the maximum output power especially, and connect them to each phase (R,S,T) respectively.

Be careful to limit the current under the rated current per the phase .

The 1-Phase terminals and receptacles output power are originated from the R and T Phase output powers.

- 19 -

Image 19

Contents DG150MI DG250MI Table of ContentsIntroduction Injuries Safety GuidelinesSuffocation from exhaust fume Electrical ShockFire Injuries to eyes and skinBurns Location of Warning labels Control Panel Unit Name of Generator SpecificationsSpecification Matrix Alternator EngineAmbient Condition PartsExternal view Name Control panelEquipment Water Temperature Monitoring Lamp for temperature HighMonitor Display Engine Oil Monitoring Lamp for oil pressure low Battery Charge Monitoring Lamp charge lamp Hour Meter GaugesFluid Level Monitoring Lamp DG250MI only Tachometer DG250MI onlyLamp Water Temperature Gauge DG250MI onlyOil Pressure Gauge DG250MI only Generator GaugesSwitch Throttle Handle Fuel Line Changeover Valve 3-way valveVoltage Regulator and Throttle Handle Voltage RegulatorTransportation Transport and InstallationUsing fuel from built-in fuel tank Using fuel from external fuel tankTransportation InstallationSelecting Cable ConnectionElectrical damages Connecting Cable Load Connection Terminal Plate 3-Phase / 1-phase 2.1 200 2 1-Phase Output Terminals & Receptacles2.2 400 Grounding Work Earth Leakage Relay and GroundingEarth leakage breaker relay has activated Operation CheckFire Burns Initialization and pre-checkChecking Engine Oil Electrical Shock InjuriesChecking Coolant / Water Viscosity and temperatureEngine Oil Capacity Checking Coolant reservoir tank / Adding coolant Checking Radiator / Adding waterCondition Checking Fan BeltCoolant Capacity TensionChecking Fuel Replacing the battery Checking BatteryChecking Fuel, Engine Oil, and Water leakage Initializing / preparation OperationPost startup check During OperationAdjustment During operation Stopping the Generator Protection⑥ FeaturesProtection Feature List Connecting to External Fuel TankOverload Turn the lever for 3-way valve to B position MaintenanceGenerator side Oil Filter Change Oil ChangeModel Isuzu Part No Cleaning / Changing Fuel Filter Cleaning / Changing Air Filter ElementChanging Coolant / Water Draining Water from Fuel TankModel Long-term Storage Storage ProceduresStacking TroubleshootingSymptoms Possible Cause Corrective Actions Generator Wiring Diagram Page Page Page Engine Wiring Diagram