Shindaiwa DG250MI, DG150MI specifications Checking Fan Belt, Coolant Capacity, Tension, Condition

Page 27

8.2.3	Coolant Capacity
						(Unit : L)

				Total Coolant Volume	(including reservoir tank)
				DG150MI		7.4 (0.4)
				DG250MI		8.5 (0.4)
			Value in ( ) shows the reservoir tank’s volume
		＊
8.3 Checking Fan Belt
✳	Also refer to the user’s manual for Engine separately
	!	Danger		:Injuries
				:Injuries
	Before performing any equipment check or maintenance, stop the engine, and remove the engine
		key. A person performing the maintenance should always keep the key.
	Close all doors and place locks during operating this equipment, to avoid injuries by unintentionally
		touching cooling fan and fan belt.

! Caution

:Burns

Do not touch the engine and muffler during operation and immediately after stopping the equipment, for the temperature can reach extremely high.

8.3.1Tension

Tension should be optimum when the fan belt has 8 to 12mm slacks, when applying finger pressure (about 98N{approximately 10kgf}) at midpoint between fan pulley and alternator pulley.

8.3.2 Condition

Check for any damage on the fan belt. Replace if necessary.

<Caution>

Refer to the <User’s manual for Engine> for adjusting and replacing of the fan belt.

- 27 -

Image 27

Contents DG150MI DG250MI Table of ContentsIntroduction Injuries Safety GuidelinesSuffocation from exhaust fume Electrical ShockInjuries to eyes and skin FireBurns Location of Warning labels Control Panel Unit Name of Generator SpecificationsSpecification Matrix Alternator EngineParts Ambient ConditionExternal view Name Control panelWater Temperature Monitoring Lamp for temperature High EquipmentMonitor Display Engine Oil Monitoring Lamp for oil pressure low Battery Charge Monitoring Lamp charge lamp Hour Meter GaugesFluid Level Monitoring Lamp DG250MI only Tachometer DG250MI onlyLamp Water Temperature Gauge DG250MI onlyOil Pressure Gauge DG250MI only Generator GaugesSwitch Throttle Handle Fuel Line Changeover Valve 3-way valveVoltage Regulator and Throttle Handle Voltage RegulatorTransportation Transport and InstallationUsing fuel from built-in fuel tank Using fuel from external fuel tankTransportation InstallationConnection Selecting CableElectrical damages Connecting Cable Load Connection Terminal Plate 3-Phase / 1-phase 2 1-Phase Output Terminals & Receptacles 2.1 2002.2 400 Grounding Work Earth Leakage Relay and GroundingEarth leakage breaker relay has activated Operation CheckFire Burns Initialization and pre-checkChecking Engine Oil Electrical Shock InjuriesViscosity and temperature Checking Coolant / WaterEngine Oil Capacity Checking Coolant reservoir tank / Adding coolant Checking Radiator / Adding waterCondition Checking Fan BeltCoolant Capacity TensionChecking Fuel Checking Battery Replacing the batteryChecking Fuel, Engine Oil, and Water leakage Initializing / preparation OperationPost startup check During OperationAdjustment During operation Stopping the Generator Protection⑥ FeaturesConnecting to External Fuel Tank Protection Feature ListOverload Turn the lever for 3-way valve to B position MaintenanceGenerator side Oil Change Oil Filter ChangeModel Isuzu Part No Cleaning / Changing Fuel Filter Cleaning / Changing Air Filter ElementDraining Water from Fuel Tank Changing Coolant / WaterModel Long-term Storage Storage ProceduresStacking TroubleshootingSymptoms Possible Cause Corrective Actions Generator Wiring Diagram Page Page Page Engine Wiring Diagram