Safety Information

Continued

We cannot foresee every use which may be made of our heaters. Check with your local ﬁre safety authority if you have questions about heater use.

Other standards govern the use of fuel gases and heat producing products for speciﬁc uses. Your local authorities can advise you about these.

Carbon Monoxide Poisoning: Direct-Fired means that all of the combustion products enter the heated space. Even though this heater operates very close to 100 percent combustion efﬁciency, it still pro- duces small amounts of carbon monoxide. Some people are more affected by carbon monoxide than others. Early signs of carbon monoxide poisoning resemble the ﬂu, with headaches, dizziness, and/or nausea. If you have these signs, the heater may not be working properly. Get fresh air at once! Check for proper ventilation and have heater serviced.

Propane Gas: Propane gas is odorless. An odor- making agent is added to propane gas. The odor helps you detect a propane gas leak. However, the odor added to propane gas can fade. Propane gas may be present even though no odor exists.

This is a propane, direct-ﬁred heater. Propane is heavier than air. If propane leaks from a connection or ﬁtting, it sinks to the ﬂoor, collecting there with the surrounding air, forming a potentially explosive mixture. Obviously, propane leaks should be avoided, so set up the propane supply with utmost care. Read Propane/LP Safety, page 4 for additional informa- tion about detecting propane leaks. Leak check new connections or reconnections with a soap and water solution and follow all connection instructions herein. Also, ask your propane dealer for advice on the propane application and supply installation and ask them to check it if there are any questions.

When the heater is to be operated in the presence of other people the user is responsible for properly ac- quainting those present with the safety precautions and instructions, and of the hazards involved.

Make certain you read and understand all warn- ings. Keep this manual for reference. It is your guide to safe and proper operation of this heater.

1.Check the heater thoroughly for damage. DO NOT operate a damaged heater.

2.DO NOT modify the heater or operate a heater which has been modiﬁed from its original condition.

3.Use only propane/LP gas.

4.Use only VAPOR WITHDRAWAL propane supply. The propane cylinder must be arranged for vapor-withdrawal, in accordance with the Compress Gas Associations, Small Propane Bottle Assembly. If there is any question about vapor withdrawal, ask your propane dealer.

5.Never use the heater if the ballast weight is not assembled onto the base. The base must be weighted to avoid tipping.

6.Use only the factory preset regulator provided with the heater. Use only replacement pressure regulators speciﬁed in this manual.

7.If used, inspect the hose before each use of the heater. If it is evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the heater being put into operation. Use replacement hose assembly kit 100427-01 (see Accessories, page 11).

8.This heater is for OUTDOOR USE ONLY, even so, make sure that there is ample fresh air ventilation. Do not use in buildings, garages or other enclosed spaces.

9.If at any time gas odor is detected, IMMEDI- ATELY DISCONTINUE operation until the source of gas has been located and corrected. Read Propane Safety, page 4 for additional information about detecting propane leaks.

10.Install the heater such that it is not directly exposed to water spray, rain and/or dripping water.

11.Maintain minimum clearance to people or normal combustible material (like paper) of 3.6 ft. (1100 mm) from top and 2 ft. (609 mm) from the reﬂector.

12.Operate only on a stable, level surface.

13.Do not spray aerosols near the heater during use or shortly thereafter.

14.Do not clean heater with combustible or cor- rosive cleaners. Use warm, soapy water.

15.Check control compartment burners and cir- culation air passageways for free air passage, make sure that there are no obstructions. These areas are a common location for spider webs, which can present a dangerous condition, damage the heater and render it unsafe for use. The heater must be checked if any of the following conditions exist:

a)Gas smell along with predominate yellow tipping of the burner.

b)Heater does not reach temperature.

c)Uneven burner glow.

d)Burner makes popping noises during nor- mal use, other than during shutdown.

114082-01A