PRODUCT
IDENTIFICATION
Dome
Reflector
Wire
Guard
Propane/LP | Control | |
Knob | ||
Cylinder | ||
| ||
Housing |
| |
Base |
|
Figure 1 - Propane/LP Table Top Patio
Heater
PRODUCT FEATURES
SAFETY PILOT
This heater has a pilot with an Oxygen Deple- tion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for table top patio heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system re- quires no matches, batteries, or other sources to light heater.
16" (40.64 cm) 16"
(40.64 cm) 
16" (40.64 cm)
30" (76.20 cm) Below Burner
UNPACKING
1.Remove heater from carton.
2.Remove all protective packaging applied to heater for shipment.
3.Check heater for any shipping damage. If heater is damaged, promptly return to dealer where you bought heater.
ASSEMBLY
INSTRUCTIONS
Tools Required:
•Phillips Head Screwdriver
•Standard Pliers
Inspect heater components for possible shipping damage. If any is found, immediately notify the dealer. Check to make sure that all components are included with your heater (see pages 12 and 13).
1.Attach burner and controls assembly to base assembly with 4 screws (see Figure 3). Tighten screws. Place operating instruction label under control knob for easy review.
2.Align 3 dome holes with the 3 studs protruding from burner top (see Figure 3). Place dome onto the studs. Install 3 cap nuts onto studs. Tighten with pliers.
The installation must conform with local codes or in the absence of local codes, The National Fuel Gas Code, ANSI Z223.1.
Cap Nuts 
Dome 
Reflector
Burner and
Controls
Assembly
Screws
Base
Assembly 
Figure 2 - Clearances from Combustibles | Figure 3 - Heater Assembly |
www.desatech.com | 5 |