Black & Decker CM1936R Preparation, Unpacking Figures A, A1, A2, Handle Adjustment Figure B, Step

PREPARATION

PLEASE REFER TO DIAGRAMS (A, B, C...) AND ITEM NUMBERS (1, 2, 3...) AS NOTED THROUGHOUT MANUAL. FOR EXAMPLE, A-1 REFERS TO ITEM 1 IN FIGURE A.

UNPACKING - (FIGURES A, A1, A2)

STEP 1: handle section A-1

Raise theinto place and secure by tightening the

two lower knobs A-2. Be careful not to pinch power cord.

To avoid being pinched, keep fingers away

fromCAUTION:area betweenPinchhandlespointwhen. raising.

STEP 2:
Carefully cut down the sides of the box on the opposite end of the handle
and fold the flap down as shown.	WARNING: Sharp blade. Keep
body parts away from blade.

STEP 3:

With the carton end cut open, remove the cardboard filler, charger, accessory bag and grass bag and push the mower out of the opened carton.

A2

HANDLE ADJUSTMENT - (FIGURE B)
Your mower has a variable height handle adjustment feature. To adjust the handle position
to suit your height preference, use the following procedure:
1.	Remove both hex nuts and flat washer B-1on the middle part of the handlebars
2.	using a 1/2 inch wrench. Remove the carriage bolts B-2.
	Slide the upper handle into one of the 3 adjustment positions B-3, aligning the holes
3.	in the upper and lower handles.
	Insert carriage bolts and install the flat washers and hex nuts, tighten securely.

6