LUBRICATION
General
Remove the ignition key to prevent accidental movement during lubrication.
If lubricating with an oil can, fill the can with engine oil.
If lubricating with grease, use grease 503 98
If the Rider is used daily it should be lubricated twice a week.
Wipe off excess lubricant after lubrication.
It is important that lubricant does not get onto the drive surfaces of the belts or pulleys. If this happens, try to clean it off with white spirit. If the belt continues to slip it must be replaced. Do not use petrol or other petroleum products to clean
Lubricating wires
Lubricate both ends of the wires, moving the controls through their full travel range while doing so. Refit the rubber protectors over the wires after lubrication. Wires with a casing will seize up unless lubricated regularly. If this happens it can lead to operating problems such as uncontrolled braking.
If a wire does seize up, remove it and hang it up vertically. Lubricate with light engine oil until the oil starts to drip from the lower end. Useful hint: Fill a small plastic bag with oil, tape it tightly around the wire casing and hang the wire vertically from the bag overnight. If this does not free up the wire then it must be replaced.
Lubrication instructions according to the schedule
1. Cutting unit
Remove the nose cowling.
Lubricate using an oil can:
- Joints and bearings
English – 57