LUBRICATION
Changing the engine oil
The engine oil must be changed after the first 8 hours of operation and every 100 hours thereafter. When operating with a heavy load or at high ambient temperatures, replace every 50 hours.
WARNING!
Engine oil can be very hot if it is drained off directly after the engine is stopped. Therefore allow the engine to cool down first.
1.Open the engine cover.
2.Place a container under the drain plug on the left side of the engine.
3.Take out the dipstick. Remove the drain plug from the left side of the engine.
4.Let the oil drain out into the container.
5.Refit the drain plug and tighten it.
6.Replace the oil filter if necessary.
7.Fill with oil to the ”FULL” mark on the dipstick. Use the grade of oil specified above.
8.Run the engine until hot and check that there is no leakage from the drain plug.
9. Gear lever
Remove the transmission cover by undoing the two screws.
Lubricate the joints and bearings on the left side using an oil can.
Push the rubber protector out of the way and lubricate the hydrostatic wire using an oil can. Press the pedal a few times and lubricate again.
Refit the rubber protector.
Refit the transmission cover.
IMPORTANT INFORMATION
Used engine oil is hazardous to health and must by law not be poured out on the ground or in the nature, but shall be handed in to a workshop or special environmental station. Avoid skin contact, wash with soap and water in the event of spillage.
62 – English