Husqvarna Pro 18 manual Inspecting the safety system

Page 42

MAINTENANCE

Inspecting the safety system

The Rider is equipped with a safety system that prevents starting or driving under the following conditions:

The engine should only be possible to start when the cutting unit is in its raised position and the hydrostat pedals are in the neutral position.

The driver does not need to be seated in the driver’s seat.

Make daily inspections to ensure that the safety system works by attempting to start the engine when one of the conditions is not met. Change the conditions and try again.

Check that the engine stops if you temporarily move out off the driver’s seat while the cutting unit is lowered or the hydrostat pedals are not in the neutral position.

Startmotor

Ignition system

Works

Does not work

English – 41

Image 42

Contents Rider Pro 15 Rider Pro Contents Driving and transport on public roads InstructionDear customer TowingSafety Instructions Good serviceSerial number Explanation of Symbols Read the instructionsSafety instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationSpeed limiter Cutting unit Location of the controls ProPresentation Choke lever Presentation PROThrottle control ChronometerLever for adjustment of the cutting height Lift lever for cutting unitParking brake SeatFuelling Throttle control Lift lever for cutting unit Lights and power outlet Driving Cutting tipsRelease lever Driving PRO Before startingStarting the engine Driving PRO Driving the machine Stopping the engine Before starting Driving PRO Driving the machine Stopping the engine Maintenance Maintenance scheduleYear Year 100 300 Front cover Removing of the machine hoodsEngine cover Pro Transmission coverRight-hand fender Pro Left-hand fender ProChecking and adjustment of the steering wires Checking and adjusting the choke wire Adjusting the parking brakeChecking and adjustment of the throttle wire Poorly adjusted brakes can result in reduced braking powerReplacement of the fuel filter Pro Muffler air intake Cleaning the pulse air filterChecking of the fuel pump’s air filter Check the transmission’s air intakeReplacing the air filter Pro Maintenance Cleaning the engine and muffler Checking the engine’s cooling air intakeCheck the level of the battery acid Procedures on contact with acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Replacing the light bulbs, Pro Fuses Checking the tyre pressureFitting the cutting unit Observe caution to avoid trapping your handInstalling BioClip Removing the cutting unitChecking and adjusting the cutting unit’s ground pressure Cutting HeightChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitBelt replacement on BioClip Replacing the cutting unit beltBelt change on Combi Maintenance Service position for the cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip 90, Combi Removal of BioClip plug CombiLubrication chart LubricationLubrication Lubricating wires GeneralPedal mechanism in frame tunnel Pro Chains in frame tunnel Triangular link and jointsDriver’s seat Throttle and choke wires, lever bearings Belt tensionerEngine oil Gear lever Changing the engine oilParking brake wire Transmission oil levelTransmission Replacing the oil filter Hydraulic oil filter, changeTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverWiring Diagram PRO BL =BR = Technical Data Cutting unit BioClip Side ejector Rear ejectorCombi EU-DECLARATION of Conformity EU declaration of conformity Only applies to EuropeServicejournal Pre-delivery serviceWork done Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´z+H.6¶6*¨ Page 114 01 2003W07