Husqvarna Pro 18 manual Service position for the cutting unit, Placing in service position

Page 51

MAINTENANCE

Service position for the cutting unit

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.

Placing in service position

1.Position the machine on flat ground. Apply the parking brake (A). Adjust the cutting unit to the lowest cutting height and lower the cutting unit

(B).

2.Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood).

3.Remove the two support wheels from under the front hood.

50 – English

Image 51

Contents Rider Pro 15 Rider Pro Contents Towing InstructionDear customer Driving and transport on public roadsSafety Instructions Good serviceSerial number Read the instructions Explanation of SymbolsGeneral use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationSpeed limiter Location of the controls Pro Cutting unitPresentation Chronometer Presentation PROThrottle control Choke leverLift lever for cutting unit Lever for adjustment of the cutting heightParking brake SeatFuelling Throttle control Lift lever for cutting unit Lights and power outlet Driving Cutting tipsRelease lever Driving PRO Before startingStarting the engine Driving PRO Driving the machine Stopping the engine Before starting Driving PRO Driving the machine Stopping the engine Maintenance Maintenance scheduleYear Year 100 300 Transmission cover Removing of the machine hoodsEngine cover Pro Front coverLeft-hand fender Pro Right-hand fender ProChecking and adjustment of the steering wires Poorly adjusted brakes can result in reduced braking power Adjusting the parking brakeChecking and adjustment of the throttle wire Checking and adjusting the choke wireReplacement of the fuel filter Pro Check the transmission’s air intake Cleaning the pulse air filterChecking of the fuel pump’s air filter Muffler air intakeReplacing the air filter Pro Maintenance Checking the engine’s cooling air intake Cleaning the engine and mufflerCheck the level of the battery acid Procedures on contact with acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Replacing the light bulbs, Pro Checking the tyre pressure FusesObserve caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Installing BioClipCutting Height Checking and adjusting the cutting unit’s ground pressureReplacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelismBelt change on Combi Maintenance Placing in service position Service position for the cutting unitMaintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, CombiLubrication Lubrication chartLubrication General Lubricating wiresPedal mechanism in frame tunnel Pro Chains in frame tunnel Triangular link and jointsDriver’s seat Belt tensioner Throttle and choke wires, lever bearingsEngine oil Changing the engine oil Gear leverParking brake wire Transmission oil levelTransmission Hydraulic oil filter, change Replacing the oil filterProblem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageBL = Wiring Diagram PROBR = Technical Data Cutting unit BioClip Side ejector Rear ejectorCombi EU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityServicejournal Pre-delivery serviceWork done Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´z+H.6¶6*¨ Page 2003W07 114 01