Husqvarna GT48XLSi warranty To Transport See Fig, Battery INDICATOR/CHARGING Plug See Fig

Page 12

OPERATION

TO TRANSPORT (See Fig. 14)

When pushing or towing your tractor, ensure transmission is disengaged by placing freewheel control in freewheel- ing position. Free wheel control is located under the seat.

•Raise attachment lift to highest position with attachment lift control.

•Raise seat and pull freewheel control up and back into the slot and release so it is held in the disengaged position.

•Do not push or tow tractor at more than two (2) mph (3,2 km/h).

•To reengage transmission, reverse above procedure.

TRANSMISSION ENGAGED

TRANSMISSION DISENGAGED

Fig. 14

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, ensure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

HEADLIGHTS

Headlights can be used without your passcode and with the engine off.

WITH ENGINE OFF:

•Press headlight button (H) once to turn headlights on for one minute.

•Press and hold headlight button (H) until headlights blink twice to turn headlights on for five minutes.

NOTE: If the engine is running and shuts off for any reason, the headlights will also shut off.

BATTERY INDICATOR/CHARGING PLUG (See Fig. 15)

The Battery Indicator displays the status of the battery. There are three different indicator lights:

1.

RED

Charge necessary

2.

YELLOW

Charge recommended

3.

GREEN

Charge not necessary

RED

YELLOW

GREEN

CHARGING PLUG

Fig. 15

NOTE: Wait 30 minutes after battery use for accurate charge indication.

For charging, the battery can be charged through the Charging Plug.

WARNING: The Charging Plug only fits CTEK's 12 volt chargers between 0.8 - 10 Amps and must only be used with these chargers.

See your local dealer for an available charger.

BATTERY INDICATOR BUTTON (See Fig. 16)

The battery indicator button (I) is located on the SmartSwitch Ignition module and is used to display the status of the battery. The indicator will only work after the passcode has been entered and is blinking green.

•Press and hold battery indicator button (I) for three (3) seconds.

•The SmartSwitch Ignition Button (F) will light up and indicate the battery status as follows:

RED

Charge necessary

RED AND GREEN

Charge recommended

GREEN

Charge not necessary

•Press the battery indicator button (I) once to stop viewing the battery status.

NOTE: When the battery is too low and after the first un- successful start attempt, the battery indicator button will blink for two (2) seconds and then stay lit until battery is charged or until approximately five (5) minutes since last attempted start.

F

I

Fig. 16

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Operator’s Manual Manual de Operario English/SpanishSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To Adjust Mower Cutting Height See Fig To USE Throttle Control D SeeTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Stop Mower Blades Reverse Operation System ROS See FigBattery INDICATOR/CHARGING Plug See Fig Battery Indicator Button See FigTo Transport See Fig Resetting Ignition System Passcode See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineSmartswitch Warning Lights See Fig To Start EnginePRE-START StartingMowing Tips Purge TransmissionHour Meter Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning Deck Washout Port See Fig Service and Adjustments To Install Mower SeeTo Remove Mower See Fig O PSecure with small washer and small retainer spring as shown To Level Mower Mower, or, counterclockwise Loosen to lower Front mowerTo Replace Mower Blade Drive Belt To Check BrakeFront Wheel TOE-IN/CAMBER PulleysBelt Installation To Replace Motion Drive Belt See FigTo Remove Wheel See Fig Belt RemovalTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Replace LED Headlight Interlocks and RelaysSmartswitch Ignition System Lights See Fig To Remove Hood and Grill Assembly See FigREMOVAL/REPLACEMENT To Adjust Throttle Control CableStorage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXReglas DE Seguridad AdvertenciaFuncionamiento General II. Funcionamiento EN PendientesIII. Niños IV. RemolqueServicio Manipulación Segura DE LA GasolinaTabla DE Materias Especificaciones DEL ProductoResponsabilidades DEL Cliente Piezas SIN Montar MontajeHerramientas Necesarias Para EL Montaje Para Remover EL Tractor DE LA Caja DE CartónRevisión DE LA Presión DE LAS Llantas Revisión DE LA Nivelación DEL ConjuntoRevisión DE LA Posición Adecuada DE Todas LAS Correas Revisión DEL Sistema DE FrenosOperación Familiaricese CON SU Tractor Amperímetro Indica la carga + o la descarga de la bateríaComo Usar SU Tractor Para Ajustar EL Freno DE Estacionamiento Vea FigParada Vea Fig Cómo Usar EL Control DEL Cierre Diferencial Para Ajustar LAS Ruedas Calibradoras Vea Fig Para Operar LA SegadoraPara Parar LAS Cuchillas DE LA Segadora Sistema DE Operación EN Reversa ROS Vea FigPara Transportar Vea Fig RemolquedecarretillasootrosaccesoriosFaros Delanteros Testigo DE BATERÍA/CONECTOR DE Carga Vea FigAntesde Hacerarrancar EL Motor Revise EL Nivel DE Aceite DEL MotorAgregue Gasolina Para Operar DE LA Valvula DE Gasolina DE Reserva Vea FigArranque DEL Motor Consejos Para Segar Purgar LA TransmisiónContador Horario Mantenimiento Recomendaciones GeneralesTabla DE Lubricación Antes DE Cada USOTractor Operación DEL FrenoCuidado DE LA Cuchilla LlantasMotor Limpieza Puerto DE Lavado DE LA Cubierta Vea Fig Servicio Y Ajustes Instale LA Segadora VeaBarra Antibalanceo S Instale la correa pasándola por encima de la polea del motor Para Nivelar LA Segadora Controlar Y Ajustar EL Freno Impresión / Inclinación DE LAS Ruedas DEL- AnterasPara Cambiar LA Correa DE Impulsión DE Movimiento Vea Fig Desmontaje DE LA CorreaMontaje DE LA Correa Para Remover LAS Ruedas Vea FigPara Hacer Arrancar EL Motor CON UNA BAT- Ería Baja Vea Fig Reemplazar LA Bateria Vea FigSustitución DEL Faro LED Entrecierre Y ReléLuces DEL Sistema DE Arranque Smartswitch Vea Fig TransmisiónPara Remover EL Conjunto DEL Capota Y DEL Enrejado Vea Fig REMOCIÓN/REEMPLAZO DE LA TransmisiónAlmacenamiento OtrosSistema DE Combustible Aceite DEL MotorIdentificación DE Problemas Problema Causa CorrecciónFuncionando cuando Pendiente Productos de consumo equipados con ruedas Garantía limitada Cómo Obtener Servicio Transmisión** Giro cero EZ y MZ Moldeada, no reforzada Service NOTES/ Aviso Service NOTES/ Aviso 11/15/13 AP
Top Page Image Contents