Husqvarna GT48XLSi Service and Adjustments, To Remove Mower See Fig, To Install Mower See, O P

Page 21

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

•Depress brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Shut engine off and lock the SmartSwitch Ignition.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 29)

•Place attachment clutch in “DISENGAGED” position.

•Lower attachment lift lever to its lowest position.

•Remove mower belt from electric clutch pulley (M). See Mower Drive Belt Removal in "TO REPLACE MOWER BLADE DRIVE BELT" in this section.

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Go to either side of mower and disconnect mower suspension arm (A) from chassis and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

•Go to other side of mower and disconnect the suspen- sion arm and rear lift link.

CAUTION: After rear lift links are discon- nected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

•Slide mower out from under right side of tractor.

TO INSTALL MOWER (See Fig. 29 - 36)

Ensure tractor is on level surface and engage parking brake.

•Lower attachment lift lever to its lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

NOTE: Ensure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED)

ANTI-SWAY BAR (S)
TOWARDS	TOWARDS
TRANSAXLE	MOWER DECK
90° END	INTEGRATED WASHER END

Fig. 30

A

C

D

S

D

M F O P

Q

E

H

B

Fig. 29

21

Image 21

Contents English/Spanish Operator’s Manual Manual de OperarioSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Throttle Control D See To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Operate Mower To Adjust Gauge Wheels See FigTo Stop Mower Blades Reverse Operation System ROS See FigBattery INDICATOR/CHARGING Plug See Fig Battery Indicator Button See FigTo Transport See Fig Before Starting the Engine Resetting Ignition System Passcode See FigCheck Engine OIL Level ADD GasolineTo Start Engine Smartswitch Warning Lights See FigPRE-START StartingMowing Tips Purge TransmissionHour Meter Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigEngine Cleaning Deck Washout Port See Fig To Install Mower See Service and AdjustmentsTo Remove Mower See Fig O PSecure with small washer and small retainer spring as shown Mower, or, counterclockwise Loosen to lower Front mower To Level MowerTo Check Brake To Replace Mower Blade Drive BeltFront Wheel TOE-IN/CAMBER PulleysTo Replace Motion Drive Belt See Fig Belt InstallationTo Remove Wheel See Fig Belt RemovalReplacing Battery See Fig To Start Engine with a Weak Battery See FigTo Replace LED Headlight Interlocks and RelaysTo Remove Hood and Grill Assembly See Fig Smartswitch Ignition System Lights See FigREMOVAL/REPLACEMENT To Adjust Throttle Control CableOther StorageFuel System Engine OILProblem Cause Correction TroubleshootingBattery will not To run when operFires when turn Engine continuesConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationAdvertencia Reglas DE SeguridadFuncionamiento General II. Funcionamiento EN PendientesIV. Remolque III. NiñosServicio Manipulación Segura DE LA GasolinaTabla DE Materias Especificaciones DEL ProductoResponsabilidades DEL Cliente Montaje Piezas SIN MontarHerramientas Necesarias Para EL Montaje Para Remover EL Tractor DE LA Caja DE CartónRevisión DE LA Nivelación DEL Conjunto Revisión DE LA Presión DE LAS LlantasRevisión DE LA Posición Adecuada DE Todas LAS Correas Revisión DEL Sistema DE FrenosOperación Amperímetro Indica la carga + o la descarga de la batería Familiaricese CON SU TractorComo Usar SU Tractor Para Ajustar EL Freno DE Estacionamiento Vea FigParada Vea Fig Cómo Usar EL Control DEL Cierre Diferencial Para Operar LA Segadora Para Ajustar LAS Ruedas Calibradoras Vea FigPara Parar LAS Cuchillas DE LA Segadora Sistema DE Operación EN Reversa ROS Vea FigRemolquedecarretillasootrosaccesorios Para Transportar Vea FigFaros Delanteros Testigo DE BATERÍA/CONECTOR DE Carga Vea FigRevise EL Nivel DE Aceite DEL Motor Antesde Hacerarrancar EL MotorAgregue Gasolina Para Operar DE LA Valvula DE Gasolina DE Reserva Vea FigArranque DEL Motor Consejos Para Segar Purgar LA TransmisiónContador Horario Recomendaciones Generales MantenimientoTabla DE Lubricación Antes DE Cada USOOperación DEL Freno TractorCuidado DE LA Cuchilla LlantasMotor Limpieza Puerto DE Lavado DE LA Cubierta Vea Fig Servicio Y Ajustes Instale LA Segadora VeaBarra Antibalanceo S Instale la correa pasándola por encima de la polea del motor Para Nivelar LA Segadora Impresión / Inclinación DE LAS Ruedas DEL- Anteras Controlar Y Ajustar EL FrenoDesmontaje DE LA Correa Para Cambiar LA Correa DE Impulsión DE Movimiento Vea FigMontaje DE LA Correa Para Remover LAS Ruedas Vea FigReemplazar LA Bateria Vea Fig Para Hacer Arrancar EL Motor CON UNA BAT- Ería Baja Vea FigSustitución DEL Faro LED Entrecierre Y ReléTransmisión Luces DEL Sistema DE Arranque Smartswitch Vea FigPara Remover EL Conjunto DEL Capota Y DEL Enrejado Vea Fig REMOCIÓN/REEMPLAZO DE LA TransmisiónOtros AlmacenamientoSistema DE Combustible Aceite DEL MotorProblema Causa Corrección Identificación DE ProblemasFuncionando cuando Pendiente Productos de consumo equipados con ruedas Garantía limitada Cómo Obtener Servicio Transmisión** Giro cero EZ y MZ Moldeada, no reforzada Service NOTES/ Aviso Service NOTES/ Aviso 11/15/13 AP