Husqvarna GT48XLSi warranty Table of Contents

Page 4

PRODUCT SPECIFICATIONS

Gasoline Capacity

4 Gallons/15,14 L

and type:

Regular Unleaded

Oil Type:

SAE 30 (above 32°F/0°C)

(API: SG-SL)

SAE 5W30 (below 32°F/0°C)

Oil Capacity:

W/Filter:

64

Oz./1,65 L

 

W/out Filter:

60

Oz./1,4 L

Spark Plug:

Champion 795135

 

(Gap: .030"/ 0,76 mm)

Charging System:

16 Amps @ 3600 RPM

 

 

 

 

Battery:

Amp/Hr:

28

 

 

Min. CCA:

230

 

Case size:

U1R

Blade Bolt Torque:

45-55 Ft. Lbs./62-75 Nm

 

 

 

 

CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problem you cannot easily remedy, please contact your nearest authorized service center/department. We have competent, well-trained techni- cians and the proper tools to service or repair this tractor.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tractor properly. Always observe the “SAFETY RULES”.

CUSTOMER RESPONSIBILITIES

•Read and observe the safety rules.

•Follow a regular schedule in maintaining, caring for and using your tractor.

•Follow the instructions under “Maintenance” and “Stor- age” sections of this manual.

•Wear proper Personal Protective Equipment (PPE) while operating this machine, including (at a minimum) sturdy footwear, eye protection, and hearing protection. Do not mow in short and/or, open toed footwear.

•Always let someone know you are outside mowing.

WARNING: This tractor is equipped with an internal com- bustion engine and should not be used on or near any un- improved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

A spark arrester for the muffler is available through your nearest authorized service center/department.

In the state of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.

TABLE OF CONTENTS

SAFETY RULES

2-3

PRODUCT SPECIFICATIONS

4

CUSTOMER RESPONSIBILITIES

4

ASSEMBLY

5-6

OPERATION

7-15

MAINTENANCE SCHEDULE

16

MAINTENANCE

16-20

SERVICE AND ADJUSTMENTS

21-27

STORAGE

28

TROUBLESHOOTING

29-30

WARRANTY

31-34

ESPAÑOL

36

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Operator’s Manual Manual de Operario English/SpanishSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To Adjust Mower Cutting Height See Fig To USE Throttle Control D SeeTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Stop Mower Blades Reverse Operation System ROS See FigBattery Indicator Button See Fig Battery INDICATOR/CHARGING Plug See FigTo Transport See Fig Resetting Ignition System Passcode See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineSmartswitch Warning Lights See Fig To Start EnginePRE-START StartingPurge Transmission Mowing TipsHour Meter Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning Deck Washout Port See Fig Service and Adjustments To Install Mower SeeTo Remove Mower See Fig O PSecure with small washer and small retainer spring as shown To Level Mower Mower, or, counterclockwise Loosen to lower Front mowerTo Replace Mower Blade Drive Belt To Check BrakeFront Wheel TOE-IN/CAMBER PulleysBelt Installation To Replace Motion Drive Belt See FigTo Remove Wheel See Fig Belt RemovalTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Replace LED Headlight Interlocks and RelaysSmartswitch Ignition System Lights See Fig To Remove Hood and Grill Assembly See FigREMOVAL/REPLACEMENT To Adjust Throttle Control CableStorage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXReglas DE Seguridad AdvertenciaFuncionamiento General II. Funcionamiento EN PendientesIII. Niños IV. RemolqueServicio Manipulación Segura DE LA GasolinaEspecificaciones DEL Producto Tabla DE MateriasResponsabilidades DEL Cliente Piezas SIN Montar MontajeHerramientas Necesarias Para EL Montaje Para Remover EL Tractor DE LA Caja DE CartónRevisión DE LA Presión DE LAS Llantas Revisión DE LA Nivelación DEL ConjuntoRevisión DE LA Posición Adecuada DE Todas LAS Correas Revisión DEL Sistema DE FrenosOperación Familiaricese CON SU Tractor Amperímetro Indica la carga + o la descarga de la bateríaPara Ajustar EL Freno DE Estacionamiento Vea Fig Como Usar SU TractorParada Vea Fig Cómo Usar EL Control DEL Cierre Diferencial Para Ajustar LAS Ruedas Calibradoras Vea Fig Para Operar LA SegadoraPara Parar LAS Cuchillas DE LA Segadora Sistema DE Operación EN Reversa ROS Vea FigPara Transportar Vea Fig RemolquedecarretillasootrosaccesoriosFaros Delanteros Testigo DE BATERÍA/CONECTOR DE Carga Vea FigAntesde Hacerarrancar EL Motor Revise EL Nivel DE Aceite DEL MotorAgregue Gasolina Para Operar DE LA Valvula DE Gasolina DE Reserva Vea FigArranque DEL Motor Purgar LA Transmisión Consejos Para SegarContador Horario Mantenimiento Recomendaciones GeneralesTabla DE Lubricación Antes DE Cada USOTractor Operación DEL FrenoCuidado DE LA Cuchilla LlantasMotor Limpieza Puerto DE Lavado DE LA Cubierta Vea Fig Instale LA Segadora Vea Servicio Y AjustesBarra Antibalanceo S Instale la correa pasándola por encima de la polea del motor Para Nivelar LA Segadora Controlar Y Ajustar EL Freno Impresión / Inclinación DE LAS Ruedas DEL- AnterasPara Cambiar LA Correa DE Impulsión DE Movimiento Vea Fig Desmontaje DE LA CorreaMontaje DE LA Correa Para Remover LAS Ruedas Vea FigPara Hacer Arrancar EL Motor CON UNA BAT- Ería Baja Vea Fig Reemplazar LA Bateria Vea FigSustitución DEL Faro LED Entrecierre Y ReléLuces DEL Sistema DE Arranque Smartswitch Vea Fig TransmisiónPara Remover EL Conjunto DEL Capota Y DEL Enrejado Vea Fig REMOCIÓN/REEMPLAZO DE LA TransmisiónAlmacenamiento OtrosSistema DE Combustible Aceite DEL MotorIdentificación DE Problemas Problema Causa CorrecciónFuncionando cuando Pendiente Productos de consumo equipados con ruedas Garantía limitada Cómo Obtener Servicio Transmisión** Giro cero EZ y MZ Moldeada, no reforzada Service NOTES/ Aviso Service NOTES/ Aviso 11/15/13 AP
Top Page Image Contents