Husqvarna GT48XLSi warranty To Start Engine with a Weak Battery See Fig, Replacing Battery See Fig

Page 26

SERVICE AND ADJUSTMENTS

TO START ENGINE WITH A WEAK BATTERY (See Fig. 46)

WARNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

WEAK

FULLY

OR DEAD

CHARGED

BATTERY

BATTERY

 

02614

Fig. 46

REPLACING BATTERY (See Fig. 47)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

Lift hood to raised position.

Remove terminal cover.

Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

Install new battery with terminals in same position as old battery.

Reinstall terminal cover.

First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely.

Connect BLACK grounding cable to negative (-) battery terminal with remaining bolt and nut. Tighten securely

Close hood.

NEGATIVE (BLACK)

CABLE

TERMINAL

COVER

POSITIVE (RED)

CABLE

Fig. 47

TO REPLACE LED HEADLIGHT

Raise hood.

Disconnect harness from LED light.

Remove mounting screws to remove LED light, reflector and lens.

Replace LED light, reflector, or lens as needed.

Reinstall using mounting screws previously removed.

Reconnect harness to LED light.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring.

TO REPLACE FUSE (See Fig. 48)

Unit has two automotive type fuses. Replace primary operation fuse with a 20 amp and the differential lock actuator fuse with a 10 amp. The fuse holders are located behind the dash.

Fig. 48

26

Image 26
Contents Operator’s Manual Manual de Operario English/SpanishGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts AssemblyTools Required for Assembly ToremovetractorfromcartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo USE Throttle Control D See To USE Cruise Control J See FigTo Stop Mower Blades To Adjust Gauge Wheels See FigTo Operate Mower Reverse Operation System ROS See FigTo Transport See Fig Battery INDICATOR/CHARGING Plug See FigBattery Indicator Button See Fig Check Engine OIL Level Resetting Ignition System Passcode See FigBefore Starting the Engine ADD GasolinePRE-START Smartswitch Warning Lights See FigTo Start Engine StartingHour Meter Mowing TipsPurge Transmission General Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine Cleaning Deck Washout Port See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See O PSecure with small washer and small retainer spring as shown To Level Mower Mower, or, counterclockwise Loosen to lower Front mowerFront Wheel TOE-IN/CAMBER To Replace Mower Blade Drive BeltTo Check Brake PulleysTo Remove Wheel See Fig Belt InstallationTo Replace Motion Drive Belt See Fig Belt RemovalTo Replace LED Headlight To Start Engine with a Weak Battery See FigReplacing Battery See Fig Interlocks and RelaysREMOVAL/REPLACEMENT Smartswitch Ignition System Lights See FigTo Remove Hood and Grill Assembly See Fig To Adjust Throttle Control CableFuel System StorageOther Engine OILTroubleshooting Problem Cause CorrectionFires when turn To run when operBattery will not Engine continuesConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXFuncionamiento General Reglas DE SeguridadAdvertencia II. Funcionamiento EN PendientesServicio III. NiñosIV. Remolque Manipulación Segura DE LA GasolinaResponsabilidades DEL Cliente Tabla DE MateriasEspecificaciones DEL Producto Herramientas Necesarias Para EL Montaje Piezas SIN MontarMontaje Para Remover EL Tractor DE LA Caja DE CartónRevisión DE LA Posición Adecuada DE Todas LAS Correas Revisión DE LA Presión DE LAS LlantasRevisión DE LA Nivelación DEL Conjunto Revisión DEL Sistema DE FrenosOperación Familiaricese CON SU Tractor Amperímetro Indica la carga + o la descarga de la bateríaParada Vea Fig Como Usar SU TractorPara Ajustar EL Freno DE Estacionamiento Vea Fig Cómo Usar EL Control DEL Cierre Diferencial Para Parar LAS Cuchillas DE LA Segadora Para Ajustar LAS Ruedas Calibradoras Vea FigPara Operar LA Segadora Sistema DE Operación EN Reversa ROS Vea FigFaros Delanteros Para Transportar Vea FigRemolquedecarretillasootrosaccesorios Testigo DE BATERÍA/CONECTOR DE Carga Vea FigAgregue Gasolina Antesde Hacerarrancar EL MotorRevise EL Nivel DE Aceite DEL Motor Para Operar DE LA Valvula DE Gasolina DE Reserva Vea FigArranque DEL Motor Contador Horario Consejos Para SegarPurgar LA Transmisión Tabla DE Lubricación MantenimientoRecomendaciones Generales Antes DE Cada USOCuidado DE LA Cuchilla TractorOperación DEL Freno LlantasMotor Limpieza Puerto DE Lavado DE LA Cubierta Vea Fig Barra Antibalanceo S Servicio Y AjustesInstale LA Segadora Vea Instale la correa pasándola por encima de la polea del motor Para Nivelar LA Segadora Controlar Y Ajustar EL Freno Impresión / Inclinación DE LAS Ruedas DEL- AnterasMontaje DE LA Correa Para Cambiar LA Correa DE Impulsión DE Movimiento Vea FigDesmontaje DE LA Correa Para Remover LAS Ruedas Vea FigSustitución DEL Faro LED Para Hacer Arrancar EL Motor CON UNA BAT- Ería Baja Vea FigReemplazar LA Bateria Vea Fig Entrecierre Y ReléPara Remover EL Conjunto DEL Capota Y DEL Enrejado Vea Fig Luces DEL Sistema DE Arranque Smartswitch Vea FigTransmisión REMOCIÓN/REEMPLAZO DE LA TransmisiónSistema DE Combustible AlmacenamientoOtros Aceite DEL MotorIdentificación DE Problemas Problema Causa CorrecciónFuncionando cuando Pendiente Productos de consumo equipados con ruedas Garantía limitada Cómo Obtener Servicio Transmisión** Giro cero EZ y MZ Moldeada, no reforzada Service NOTES/ Aviso Service NOTES/ Aviso 11/15/13 AP