Husqvarna GT48XLSi Unassembled Parts, Tools Required for Assembly, Toremovetractorfromcarton

Page 5

UNASSEMBLED PARTS

Slope Sheet

(1) Oil Drain Tube

(1) Quick Connect

*Installed by Dealer

*Brush Guard Kit

*Pedal

(2) Screw	(2) Nut
	U-Channel

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)	1/2" wrench	Tire pressure gauge
(2)	7/16" wrenches	Utility knife	Pliers

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TOREMOVETRACTORFROMCARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton.

•Remove end panels and lay side panels flat.

•Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM SKID

ADJUST SEAT (See Fig. 2)

•Sit in seat.

•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

•Release lever to lock seat in position.

A

Fig. 2

NOTE: You may now roll your tractor off the skid. Continue using the instructions that follow to remove the tractor from the skid.

TO CHECK BATTERY (See Fig. 1)

•Lift hood to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.

LABEL

Fig.1

WARNING: Before starting, read, understand and fol- low all instructions in the Operation section of this manual. Ensure tractor is in a well-ventilated area. Ensure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Release parking brake by depressing brake pedal.

•Place freewheel control in disengaged position to disengage transmission (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

Continue with the instructions that follow.

5

Image 5

Contents English/Spanish Operator’s Manual Manual de OperarioSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Operate Mower To Adjust Gauge Wheels See FigTo Stop Mower Blades Reverse Operation System ROS See FigTo Transport See Fig Battery INDICATOR/CHARGING Plug See FigBattery Indicator Button See Fig Before Starting the Engine Resetting Ignition System Passcode See FigCheck Engine OIL Level ADD GasolineTo Start Engine Smartswitch Warning Lights See FigPRE-START StartingHour Meter Mowing TipsPurge Transmission Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigEngine Cleaning Deck Washout Port See Fig To Install Mower See Service and AdjustmentsTo Remove Mower See Fig O PSecure with small washer and small retainer spring as shown Mower, or, counterclockwise Loosen to lower Front mower To Level MowerTo Check Brake To Replace Mower Blade Drive BeltFront Wheel TOE-IN/CAMBER PulleysTo Replace Motion Drive Belt See Fig Belt InstallationTo Remove Wheel See Fig Belt RemovalReplacing Battery See Fig To Start Engine with a Weak Battery See FigTo Replace LED Headlight Interlocks and RelaysTo Remove Hood and Grill Assembly See Fig Smartswitch Ignition System Lights See FigREMOVAL/REPLACEMENT To Adjust Throttle Control CableOther StorageFuel System Engine OILProblem Cause Correction TroubleshootingBattery will not To run when operFires when turn Engine continuesConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationAdvertencia Reglas DE SeguridadFuncionamiento General II. Funcionamiento EN PendientesIV. Remolque III. NiñosServicio Manipulación Segura DE LA GasolinaResponsabilidades DEL Cliente Tabla DE MateriasEspecificaciones DEL Producto Montaje Piezas SIN MontarHerramientas Necesarias Para EL Montaje Para Remover EL Tractor DE LA Caja DE CartónRevisión DE LA Nivelación DEL Conjunto Revisión DE LA Presión DE LAS LlantasRevisión DE LA Posición Adecuada DE Todas LAS Correas Revisión DEL Sistema DE FrenosOperación Amperímetro Indica la carga + o la descarga de la batería Familiaricese CON SU TractorParada Vea Fig Como Usar SU TractorPara Ajustar EL Freno DE Estacionamiento Vea Fig Cómo Usar EL Control DEL Cierre Diferencial Para Operar LA Segadora Para Ajustar LAS Ruedas Calibradoras Vea FigPara Parar LAS Cuchillas DE LA Segadora Sistema DE Operación EN Reversa ROS Vea FigRemolquedecarretillasootrosaccesorios Para Transportar Vea FigFaros Delanteros Testigo DE BATERÍA/CONECTOR DE Carga Vea FigRevise EL Nivel DE Aceite DEL Motor Antesde Hacerarrancar EL MotorAgregue Gasolina Para Operar DE LA Valvula DE Gasolina DE Reserva Vea FigArranque DEL Motor Contador Horario Consejos Para SegarPurgar LA Transmisión Recomendaciones Generales MantenimientoTabla DE Lubricación Antes DE Cada USOOperación DEL Freno TractorCuidado DE LA Cuchilla LlantasMotor Limpieza Puerto DE Lavado DE LA Cubierta Vea Fig Barra Antibalanceo S Servicio Y AjustesInstale LA Segadora Vea Instale la correa pasándola por encima de la polea del motor Para Nivelar LA Segadora Impresión / Inclinación DE LAS Ruedas DEL- Anteras Controlar Y Ajustar EL FrenoDesmontaje DE LA Correa Para Cambiar LA Correa DE Impulsión DE Movimiento Vea FigMontaje DE LA Correa Para Remover LAS Ruedas Vea FigReemplazar LA Bateria Vea Fig Para Hacer Arrancar EL Motor CON UNA BAT- Ería Baja Vea FigSustitución DEL Faro LED Entrecierre Y ReléTransmisión Luces DEL Sistema DE Arranque Smartswitch Vea FigPara Remover EL Conjunto DEL Capota Y DEL Enrejado Vea Fig REMOCIÓN/REEMPLAZO DE LA TransmisiónOtros AlmacenamientoSistema DE Combustible Aceite DEL MotorProblema Causa Corrección Identificación DE ProblemasFuncionando cuando Pendiente Productos de consumo equipados con ruedas Garantía limitada Cómo Obtener Servicio Transmisión** Giro cero EZ y MZ Moldeada, no reforzada Service NOTES/ Aviso Service NOTES/ Aviso 11/15/13 AP