5-19
Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x
OL-16000-07
Chapter 5 Managing External Resources
Managing Other External Resources
Shows all CMTS (Aggr-ID)
that are not referred by any
Subnet.
report aggr subnet=NONE;
Viewing destination point
codes (DPCs) status for
availability and congestion
status dpc id=dpc1;
Viewing Stream Control
Transmission Protocol (SCTP)
associations
status sctp-assoc id=sctpassoc1;
Taking an SCTP association
OOS
control sctp-assoc id=sctpassoc1; target-state=INS;
mode=FORCED;
Modes can be forced or graceful. Forced tears down all calls
immediately; graceful allows calls in progress to complete before
teardown.
Viewing subsystems show subsystem;
Viewing subsystems status status subsystem id=LNP_SSN; opc_id=opc;
Changing subsystem status control subsystem id=LNP_SSN; opc_id=opc; target-state=OOS;
mode=FORCED;
Viewing CA/FS status show sup-config
Changing CA/FS status
refresh rate
change sup-config type= refresh-rate; value=600
Changing NTP servers 1. Modify 'server' line(s) in /etc/ntp.conf.
2. Modify 'NTP_SERVERS' in /etc/opticall.cfg
3. Restart daemon:
/etc/init.d/xntp stop
/etc/init.d/xntp start
4. Verify configuration change:
/opt/BTSxntp/bin/ntpq -c peers"
Table 5-9 Managing External Resources (continued)
Task Sample Command