Cisco Systems 10200 manual Limitations

Chapter 3 Monitoring and Backing Up the BTS

Exporting Provisioned Data

#############################################

##### Change command_throttle_threshold #####

#############################################

change command_throttle_threshold SESSION_TYPE=CLI;THRESHOLD=100;ENABLE=Y; change command_throttle_threshold SESSION_TYPE=CORBA;THRESHOLD=100;ENABLE=Y; change command_throttle_threshold SESSION_TYPE=FTP;THRESHOLD=1000;ENABLE=Y; change command_throttle_threshold SESSION_TYPE=MNT;THRESHOLD=100;ENABLE=Y; change command_throttle_threshold SESSION_TYPE=SNMP;THRESHOLD=100;ENABLE=Y; change command_throttle_threshold SESSION_TYPE=SOAP;THRESHOLD=100;ENABLE=Y;

##################################

##### Change config_interval #####

##################################

change config_interval CONFIG_TYPE=THROTTLE;INTERVAL=15;

# Export End Time : Tue Jan 22 17:24:14 CST 2008

Limitations

Currently the export command is supported only from the CLI interface. The export command is currently not supported from other interfaces such as CORBA and SOAP.

There is a limitation on the size of the /opt/ems/export directory. Currently the size of the export directory is defined in /opt/ems/etc/bts.properties as 7500000 ~ 700 MB. During the first run of the export command, if the size of the export file is beyond the threshold limit, a warning message is shown to the user after export is finished. The warning message indicates that the export file size has exceeded the threshold and that the user needs to clean up the export directory before running the command again. During additional runs of the export command, if the export directory size is more then the threshold size, a warning is shown to the user that the space of export directory is insufficient for the export and that the user has to clear the export directory before rerunning the export command.

Creating Numbering Resource Utilization/Forecast (NRUF) Reports

The North American Numbering Plan Association (NANPA) collects, stores, and maintains how telephone numbers are used by 19 countries. Companies, like carriers, that hold telephone numbers must report to NANPA twice a year using the NRUF report. Go to http://www.nanpa.com for more information and job aids on submitting reports.

The BTS creates an NRUF report using the Number Block table. This table:

•Is a single table that is the sole reference for NANPA audits

•Can be customized

•Can be updated from data imported from other tables, changes from office-code updates, or manually

•Has the following fields:

–Number Block: NPA to NPA-NXX-XXXX—For FCC-required NANPA audit compliance, the report input is NPANXX. In markets outside of NANPA, the input can be based on either the combination of the national destination code (NDC) and the exchange code (EC), or just the EC.

–Code Holder = Y/N

–Block Holder = Y/N

–Native = Y/N

	Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x
3-10	OL-16000-07