Cisco Systems 10200 manual EMS, BDMS, CA Activestandby Standbyactive, Oos

Chapter 4 Operating the BTS

Using Status and Control Commands

Table 4-3 Using Status and Control Commands (continued)

Task	Sample Command
Changing states of	control call-agent id=CA146; target-state=FORCED-STANDBY-ACTIVE;
component pairs	Possible states:
(EMS, BDMS, CA,
and FS)		•	ACTIVE_STANDBY
		•	STANDBY_ACTIVE
		• NORMAL—Primary is active and secondary is standby.
		• FORCED-ACTIVE-STANDBY—Primary has been forced to active and
			secondary is standby.
		• FORCED-STANDBY-ACTIVE—Primary has been forced to standby and
			secondary is active.
Viewing component	status application id=CA146;
application states
Changing	control application id=CA146; action=star;node=prica06
component
applications states
	Caution This negatively impacts the performance of the BTS host.
(in-service or OOS)
Activating media	Ensure the MG exists, then enter:
gateways	control mgw id=<mgw-id>; target-state=ins; mode=forced;
	where
		•	mgw id—the voice port on the subscriber’s MTA (the voice port’s MAC
			address without hyphens)
		• target-state—ins to show in service for all activations
		• mode—forced for all activations
Setting subsystem	control subsystem_grp id=CNAM; mode=forced; target_state=UOS;
groups/OPC in or	This sets the state of the individual subsystems within the subsystem group as
OOS
	well. If a subsystem/OPC combination is taken OOS individually, the state of
	the subsystem group may be in service while some members of the group are
	out of service.
Viewing subsystem	status subsystem_grp id=CNAM
groups/OPC status

Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x

4-8 OL-16000-07