Cisco Systems 10200 manual Scheduling Commands, FTP, Corba

Chapter 4 Operating the BTS

Scheduling Commands

Table 4-5 Viewing and Deleting Transactions (continued)

Task	Sample Command
Enabling/Disabling	1. Go to the bts.properties file.
queue throttling	/opt/ems/etc/bts.properties
	2. To enable throttling, set throttleEnable to Y. To disable throttling, set
	throttleEnable to N.
	throttleEnable=Y
	3. Restart the platform.
Viewing number of	show config-interval;
commands executed
from CLI, MNT,
FTP, CORBA,
SNMP, or SOAP
interfaces
Setting number of	change command-throttle-threshold session-type=CORBA;
commands executed	threshold=2000;
from CLI, MNT,	change command-throttle-threshold session=CORBA; enable=N;
FTP, CORBA,
SNMP, or SOAP
interfaces

Scheduling Commands

The Hour and Minute Command Scheduling feature allows you to schedule command execution for a specific hour and minute.

Using start-time and recurrence command tokens, schedule command time and frequency (hourly, daily, weekly, monthly, etc.). You can remove the command at any time; if it is recurring and currently executing, it completes and is removed.

Limitations

To prevent overload and subsequent EMS degradation, limit commands to 10, each taking less than a minute.

If you schedule a command to execute, but an earlier occurence of that command is still executing, the second might fail.

Table 4-6 Scheduling Commands

	Task	Sample Command
	Adding scheduled	add scheduled_command
	commands using	verb=report;noun=system_health;keys=period;key_values=720;recurrenc
	minutes	e=MINUTE;on_minute=3,10,25,59;start_time=2007-11-08 00:00:00;
	Adding scheduled	add scheduled_command verb=report;
	commands using	noun=system_health;start_time=2007-06-30 00:00:00;
	hours	key_values=720;keys=period; recurrence=HOURLY;
		Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x
OL-16000-07			4-13