Cisco Systems 10200 Shows all Cmts Aggr-ID, Viewing subsystems status, Viewing CA/FS status

Chapter 5 Managing External Resources

Managing Other External Resources

Table 5-9 Managing External Resources (continued)

Task	Sample Command
Shows all CMTS (Aggr-ID)	report aggr subnet=NONE;
that are not referred by any
Subnet.
Viewing destination point	status dpc id=dpc1;
codes (DPCs) status for
availability and congestion
Viewing Stream Control	status sctp-assoc id=sctpassoc1;
Transmission Protocol (SCTP)
associations
Taking an SCTP association	control sctp-assoc id=sctpassoc1; target-state=INS;
OOS	mode=FORCED;
	Modes can be forced or graceful. Forced tears down all calls
	immediately; graceful allows calls in progress to complete before
	teardown.
Viewing subsystems	show subsystem;
Viewing subsystems status	status subsystem id=LNP_SSN; opc_id=opc;
Changing subsystem status	control subsystem id=LNP_SSN; opc_id=opc; target-state=OOS;
	mode=FORCED;
Viewing CA/FS status	show sup-config
Changing CA/FS status	change sup-config type= refresh-rate; value=600
refresh rate
Changing NTP servers	1. Modify 'server' line(s) in /etc/ntp.conf.
	2. Modify 'NTP_SERVERS' in /etc/opticall.cfg
	3.	Restart daemon:
		/etc/init.d/xntp stop
		/etc/init.d/xntp start
	4.	Verify configuration change:
		/opt/BTSxntp/bin/ntpq -c peers"

	Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x
OL-16000-07		5-19