2-26 System Utilities
8. At the command prompt, type VEEPROM to write any changes in the data to the EEPROM.
Figure 2-30. VEEPROM Command Prompt
NOTE:
NOTE:
When using an y of th e wr it e op t io n s , restart the system to make the new
DMI data effective.
Using STUUID 0
To use STUUID, perform the following:
1. Copy stuuid20.exe to a bootable USB drive.
2. Boot to DOS.
3. Execute stuuid20 q.
4. Execute stuuid20 s X YY where X is the PCI bus and YY is the device ID.
Figure 2-31. STUUID