Using The Scan Tool

AC Power Adapter

An AC power adapter (not included) can be used to power the Scan Tool when reprogramming from a personal computer or for off-vehicle reviewing of codes and printing.12V AC-DC converters are available at most PC and electronic stores.

The Scan Tool is equipped to accept any

110 VAC - 12 VDC wall adapter with the GND

 

 

 

12 V

 

 

following specifications:

500 mA minimum current unregulated wall power adapter 5.5 mm outside diameter

2.5 mm inside diameter

The inside tip is positive (+)

Scan Tool Power UP

3

1.Connect Power Source

Internal Battery (9V Battery), or vehicle Power DLC

AC Adapter, or cigarette lighter cable.

2.Press and Hold ON/OFF key

For 1 second until the Scan Tool turns on.

System Setup

System Setup allows:

Measurement units to be changed.

Display contrast to be changed.

Auto-Power off time to be changed.

Scan Tool information to be viewed.

Display to be checked.

Operation of the keypad to be checked.

Memory of the tool to be checked.

Scan Tool to be upgraded, or programmed for a different language.

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 3 – 7

Page 41
Image 41
Actron CP9190 manual Scan Tool Power UP, System Setup allows