ADC EMU-830 user manual Snmp Parameters Menu

September 25, 2006 Chapter 3: Provisioning

	Option	Function
	Local SLIP Subnet Mask	Allows the EMU-830 to determine if a host (TFTP
		server, SNMP management station, or trap receiver)
		is on the same local subnet. If it is, the EMU-830 can
		communicate directly with the host; if it is not,
		messages must be sent through a default router.
		0.0.0.0 is the default setting.
	SLIP Port Baud Rate	Select the SLIP Port baud rate by toggling to the
		desired rate (maximum 19200 bps).
	BOOTP Server IP	Enter the IP address for the BOOTP server to which
	Address	the EMU-830 is connected. 0.0.0.0 is the default
		setting. This information is only required if using the
		BOOTP protocol.
	BOOTP Gateway IP	Enter the IP address for the gateway for the BOOTP
	Address	server. 0.0.0.0 is the default setting. This information
		is only required if using the BOOTP protocol and the
		BOOTP server is connected through a gateway.
	Boot Mode	Select the Boot Mode by toggling between NVRAM
		(the default) or NETWORK. BootP/TFTP Server can
		be used for uploading software using the Network.
SNMP Parameters Menu

In the Config menu, press S to display the SNMP Parameters menu (Figure 3-6). This menu is used to configure the EMU-830 for operation with SNMP (ignore this section if you are not using SNMP). The SNMP Parameters menu options are listed in Table 3-6 on page 3-12.

Figure 3-6. SNMP Parameters Menu

LTPE-UM-3159-02 3-11