ADC EMU-830 user manual NEW Features, Standard Features

Chapter 1

OVERVIEW

The EMU-830 provides management for HDSL and G.SHDSL circuits using either of the following methods:

•One or more shelves of HDSL or G.SHDSL circuits can be managed by connecting a management terminal (or PC with terminal emulation software) to the EMU-830 of one shelf. The management terminal (or PC) can be connected to the EMU-830 either directly (or through modems over a dial-up network). When two or more shelves are present, the Ethernet ports of each shelf can be interconnected to form a Local Area Network (LAN). This method of management is referred to as Multishelf Terminal Access Option (Multishelf TAO).

•One or more shelves of HDSL or G.SHDSL circuits can be managed over a LAN using the Simple Network Management Protocol (SNMP). SNMP can access a shelf through its 10BASE-T Ethernet port or through its Serial Line Interface Port (SLIP) over dial-up modem connections. These methods of management are referred to as SNMP through LAN and SNMP through SLIP. The StarGazer application can be used to manage WorldDSL shelves with the EMU-830 using SNMP through LAN.

•Management of a single shelf or multshelf TAO using Telnet.

The EMU-830 List 4A and List 6A are CE marked.

NEW FEATURES

New features in this release include management of new V11 WD92xGx line cards.

Note: DSL is used throughout the remaining pages of this document when referring to both HDSL and G.SHDSL.

STANDARD FEATURES

Standard features of the EMU-830 include:

•Support of Multishelf TAO

•Support of Point-to-Multipoint (PTM) application mode (HDSL)

•Support of Single-Pair application, Two Pair, 1+1 Application Modes (WD92xGx)

•Support of Telnet access for TAO over Ethernet or SLIP port

•Doubler support for two-pair line units (HDSL)

•Support of rate-selectable HDSL line and desktop units

•Universal Termination Units (UTUs) supported as a Line Termination Unit (LTU) or Network Termination Unit (NTU) through SNMP (HDSL and G.SHDSL 1-pair)

•WorldDSL WD92xGx G.SHDSL 2-pair line cards (G.703, Nx64K, Ethernet) configurable as STU-C or STU-R

•User programmable baud rates for SLIP port

•Chassis slots & DSL loops identified in alarm reports

•Configuration changes automatically saved in NVRAM

•Automatic log out after 20 minutes of keyboard inactivity

•Backup timing circuit for external shelf clock on EMU-830 List 6A

•Firmware download protocol (TFTP, XModem)

•Traps Generation

LTPE-UM-3159-02 1-1