Password, DTE Port Trap Description | ADTRAN T3SU 300 manual

Chapter 3. Configuration

	Table 3-5. DTE Port Trap Description

Trap Type	If ENABLED, this trap is sent...

Port Status	when the unit detects a change in any of the four
Change	DTE ports. These traps may be generated when a
	DTE interface card is plugged in, a cord is re-
	moved, a port is reconfigured, a port goes into an
	error condition due to cabling problems, or a port
	goes into a test mode.

Toggle All Traps

When activated, this entry allows you to toggle ALL alarms (previously described) between their disabled and enabled states.

Figure 3-9. System Management Configuration Menu (2 of 2)

Password

Set the password required at login (up to 32 characters). The default password is adtran.

3-18

T3SU 300 User Manual

61200217L1-1

Image 50

ADTRAN T3SU 300 user manual Password, DTE Port Trap Description, Toggle All Traps

Contents

T3SU Trademark Information About this Manual Important Safety Instructions REN FIC Usoc Year 2000 Compliance Canadian Emissions Requirements Canadian Equipment Limitations Table of Contents Status Appendix C. Acronyms/Abbreviations Appendix D. Glossary Table of Contents Xii 61200217L1-1 List of Figures Line Loopback Test List of Tables List of Tables Xvi 61200217L1-1 Introduction Product Overview T3 Overview Snmp Agent TelnetNetwork Manager MIB Card Interface Option CardsHssi Card Warranty and Customer Service Introduction 61200217L1-1 Adtran Shipments Include UNPACK, INSPECT, Power UPReceiving Inspection Power Up Installing the UnitRackmount Installation Customer Provides Desktop Installation Rear Panel Function Alarm ConnectorDTE Port Interface Card Slots DTE Port 1 Hssi Interface Auxiliary Port Front Panel LAN PortDS3 Interface Control Port Terminal Main Menu Navigating Within the Menus Remote Login ConfigurationDiagnostics If you want to Press LED Descriptions LOS LED Condition Configuration DTE Ports Configuration Main Menu DS3 Network DS3 Timing DS3 FramingLine Length Data Link Remote Auto-ConfigurationDS3 Scrambler DTE Ports Port Selections DTE Ports Menu Active Port StatusInactive Apply Settings ErrorNot Installed Waiting Off When Test Idle When OffOff When OOS/OOF Forced On Select Off When OOS/OOF or TestTransmit Clock Timed Profiles Timed Profiles Screen Profiles 1 Active Profile System ManagementProfile Time 1 Local IP Address Subnet Mask Remote IP Address Auxiliary Port ModeGateway IP Address IP Security Read Community Name Modem ModeAuxiliary Port Baud Rate Trap Generation Write Community NameTrap IP Addresses Far End Alarm Trap Descriptions Trap Type If ENABLED, this trap is sent MIB II Standard Trap Descriptions Network Test Trap Descriptions Toggle All Traps PasswordDTE Port Trap Description Unit ID Terminal TimeoutAlarm Relay Date/Time Initializing String Dial String Maximum Redial Attempts Idle TimeoutConnection Timeout Pause Between Calls Hangup UtilitiesAnswer on Ring Last Modem Response If the self test results are Then 11. System Utilities Menu Save Configuration Status Network State Alarm StateNetwork Port Condition Description Data Link State Remote State Com Eqpt Fail Network has signaled a non-service affecting Interface Type Port Status Hssi Interface Condition Leads BandwidthDTE Leads LA and LB Leads Condition Interface Leads Status 61200217L1-1 Viewing Statistical Information Alarm History Main Local Statistics Menu Screen Current Alarm Count Screen Performance Parameters Bit Coding Violations CCV Bit Severely Errored Seconds PsesBit Coding Violations PCV Bit Errors MBE Bit Severely Errored Seconds CsesBit Errors FBE All statistical information not just the displayed screen Statistics 61200217L1-1 Diagnostics Diagnostics Main Menu DS3 DS3 Diagnostics Menu Data Mode DS3 Payload Loopback DTE Remote DS3 Loopback DTE PortsBert Remote Loopback with Bert Payload Loopback Payload Bert MUX DTE LoopbackMUX Bert OUT Payload and DTE Loopback Remote Payload Loopback with Bert Bert Configuration Pattern Direction Bert Information FieldsPort State Clear Errors ErrorsInsert Error Reset All Tests Diagnostics 61200217L1-1 Applications Single Port Full T3 Bandwidth Management DTESystem POINT-TO-POINT Multiport Application Multiport Application DTE 3 DTE 1 HssiDTE 2 Hssi DTE 4 Fractional T3 Carrier Application Fractional Application Hssi Local Remote Remote Snmp Management Application Remote Management Application Datalink = Enabled Appendix a Pinouts Signal Ground SG Table A-3. V.35 Interface Card Pin Assignments Ccitt Table A-4. LAN Port Pin Assignments Name Description TD+ DTE Interfaces Integrated Hssi port Specifications and FeaturesNetwork Interface DTE Rates Supported Agency Approvals VT 100 Terminal InterfaceSNMP/Telnet Environment Appendix C Acronyms/Abbreviations DDS OOF Appendix C. Acronyms/Abbreviations 61200217L1-1 Ansi AISAMI Bert BPV Ccitt CPE Channel service unit See CSU ClockingControl port CSU Dlci DCEDDS DS1 FCC FDL LAN LOS MIB NRZ SES POPPstn Telnet SnmpTDM Yellow alarm WAN Appendix D. Glossary 61200217L1-1 Index DS3 Index-3 Index-4 61200217L1-1 Index-5 Yellow alarm traps Repair and Return Pre-Sales Inquiries and Applications SupportPost-Sale Support