Agilent Technologies manual Agilent 1100 Series Interfaces

Introduction to the Quaternary Pump

Agilent 1100 Series Interfaces

Agilent 1100 Series Interfaces

The Agilent 1100 Series modules provide the following interfaces:

Table 31	Agilent 1100 Series Interfaces
			DA Detector		Thermostatted
			MW Detector	VW Detector	Column	Vacuum
Interface Type	Pumps	Autosampler	FL Detector	RI Detector	Compartment	Degasser
CAN	Yes	Yes	Yes	Yes	Yes	No
GPIB	Yes	Yes	Yes	Yes	Yes	No
RS-232C	Yes	Yes	Yes	Yes	Yes	No
APG Remote	Yes	Yes	Yes	Yes	Yes	Yes
Analog	Yes	No	2 ×	1 ×	No	Yes*
Interface board	Yes	Yes	Yes	Yes	No	No

*The vacuum degasser will have a special connector for specific use. For details, see the degasser manual.

•The CAN connectors serve as the interface between the Agilent 1100 Series modules themselves,

•the GPIB connector serves as the interface between an Agilent1100 module and the Agilent ChemStation,

•RS-232C provides an interface to a computer,

•the APG remote connector serves as the interface between the Agilent 1100 and other Agilent (APG remote compatible) products,

•the analog output connector(s) provide an analog signal output,

•the interface board slot (not common to all modules) provides specific interfacing needs (external contacts, BCD, LAN and so on).

For identification and location of the connectors see Figure 3 on page 22.

218