Viewing and Editing Parameters
The last
PowerFlex 40 and 400 Drive Control Logic
The following is an example of basic integral keypad and display functions. This example provides basic navigation instructions and illustrates how to program the first Program Group parameter.
Step | Description | Key(s) | Example | |
Displays | ||||
|
|
| ||
| When power is applied, the last |
| VOLTS | |
| parameter number is briefly displayed with flashing characters. The |
| AMPS | |
1 |
|
| HERTZ | |
display then defaults to that parameter’s current value. (Example | PROGRAM | FAULT | ||
| shows the value of d001 [Output Freq.] with the drive stopped.) |
|
| |
2 | Press Esc or Sel until the Group Menu letter begins to flash. |
| VOLTS | |
| or | AMPS | ||
|
| HERTZ | ||
|
| PROGRAM | FAULT | |
3 | Press the Up Arrow or Down Arrow to scroll through the group menu |
|
| |
(d, P and A). | or |
| ||
|
|
| ||
4 | Press Enter or Sel to enter a group. The right digit of the last viewed | or | VOLTS | |
parameter in that group will flash. | AMPS | |||
|
|
| HERTZ | |
|
| PROGRAM | FAULT | |
5 | Press the Up Arrow or Down Arrow to scroll through the parameters |
|
| |
that are in the group. | or |
| ||
|
|
| ||
6 | Press Enter or Sel to view the value of a parameter. If you do not want | or | VOLTS | |
to edit the value, press Esc to return to the parameter number. | AMPS | |||
|
|
| HERTZ | |
|
| PROGRAM | FAULT | |
| Press Enter or Sel to enter program mode to edit the parameter value. | or | VOLTS | |
7 | The right digit will flash and the Program LED will illuminate if the | FAULT | ||
PROGRAM | ||||
|
|
| AMPS | |
|
|
| HERTZ | |
| parameter can be edited. |
|
| |
| Press the Up Arrow or Down Arrow to change the parameter value. If | or |
| |
8 | desired, press Sel to move from digit to digit or bit to bit. The digit or |
| ||
|
| |||
| bit that you can change will flash. |
|
|
Press Esc to cancel a change. The digit will stop flashing, the previous value is restored and the Program LED will turn off.
9OR
| Press Enter to save a change. The digit will stop flashing and the |
| VOLTS |
|
|
| AMPS |
| Program LED will turn off. |
| HERTZ |
| PROGRAM | FAULT | |
| Press Esc to return to the parameter list. Continue to press Esc to back |
| VOLTS |
| out of the programming menu. |
| AMPS |
10 |
|
| HERTZ |
If pressing Esc does not change the display, then d001 (Output | PROGRAM | FAULT | |
|
|
| |
| Frequency) is displayed. Press Enter or Sel to enter the group menu. |
|
|
| Table 19 |
|
|
F232120 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 31 |