AC Drive Diagnostics/Parameter Viewing

Human Interface Module (HIM or Parameter Unit)

Installation/Removal

The following are instructions for installing/removing the Human Interface Module (P/N F370597) on the drive for parameter viewing and basic troubleshooting. The parameter unit (F370597) and instructions (F232120) are included in the Parameter Kit (P/N F744501).

CAUTION

Users are prohibited from changing parameter values unless specifically instructed by the washer-extractor manufacturer. Modification to parameter values may present potential harmful operating conditions for both hardware and personnel.

W673

WARNING

To reduce risk of electric shock, severe injury or death, allow machine power to remain off for three minutes minimum prior to working in and around AC drive. Proceed with caution.

W662

Installing the HIM

Allen-Bradley 1305-Series AC Drives

3.Slide blank panel cover toward base of drive and remove it. Place top edge of HIM approximately 1/2 inch from top edge of the cover. Push inward on bottom of HIM and slide HIM up (toward the top of the drive) into position.

Removing the HIM

1.Remove power from machine at main disconnect. Delay approximately three minutes.

2.Lower hinged panel located below HIM.

3.Press retaining lever located directly beneath HIM. Slide HIM downward and remove it from drive.

4.Reinstall blank panel cover. Close hinged panel.

External HIM Connection

The HIM unit can be installed using an adapter cable (P/N P370716). This method of attaching the HIM uses an external connector shown in Figure 44. The HIM unit operates in the same manner in this configuration.

NOTE: If the HIM is removed while the drive is powered, a communication fault (Serial Fault #10) will occur and the drive will be disabled. Cycle power to the drive to reset the fault condition.

1.Remove power from machine at main disconnect. Delay approximately three minutes.

2.Lower the hinged panel located below the HIM.

ESC

Stopped+0.

 

00

Hz

SEL

 

 

 

External HIM Cable Connection

Retaining Lever

Hinged Panel

Human Interface

Module

Blank Panel Cover

U079ME3A

Figure 44

F232120

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

73