Ampro Corporation 486E manual IDE Interface Configuration, Connector Type Mating Connector

Product Reference

Table 2–25. IDE Drive Interface Connector (J12) (continued)

Pin	Signal Name	Function	In/Out
33	HOST A1	Drive address 1	OUT
34	RSVD	Reserved	N/C
35	HOST AD0	Drive address 0	OUT
36	HOST AD2	Drive address 2	OUT
37	-HOST CS0	Chip select	OUT
38	-HOST CS1	Chip select	OUT
39	-HOST SLV/ACT	Drive active/drive slave	10K Pull-up
40	GND	Ground	OUT

Table 2–26. J12 Mating Connector

Connector Type	Mating Connector
Ribbon	3M 3417-7600
Discrete Wire	MOLEX Housing 22-55-2402
	PIN 16-02-0103

IDE Interface Configuration

Use SETUP to specify the IDE hard disk drive type. Refer to the SETUP section later in this chapter for details.

If a drive type whose displayed parameters match the drive being used is not found use drive type 48 or 49. These permit manual entry of the drive parameters described in the documentation provided by the drive’s manufacturer. Use drive type AUTO for all IDE drives. AUTO automatically configures the drive type parameters from information provided by the drive itself.

2–31