Product Reference
2–9
DRAM
There is no DRAM soldered on board. The Little Board/486e CPU will support up to 64M byte of
system DRAM. A single vertical 168-pin DI M M soc ket su ppo rtin g sy mme trical EDO 3.3V mo dules
is used.
When the system boots, the BIOS measures the amount of memory installed and configures the
internal memory controller. No jumpering or manual configuration is required. The amount of
memory found can be displayed by running SETUP. Saving SETUP automatically stores this figure
in the Configuration Memory.
Note
If you change the amount of memory installed, you must run SETUP
again to save the new value in the Configuration Memory.
Onboard memory is allocated as follows (standard for the PC architecture):
! The first 640K bytes of DRAM are assigned to th e DO S re gion 0000 0h to 9FFF Fh.
! DRAM in the top 384K bytes of the first 1M byte is no t ava ilable for use r pro gram s. D RAM i s
mapped into the top 64K to shadow the ROM BIOS. DRAM can also be mapped into a portion of
this region to shadow a video BIOS (a SETUP option).
! The remaining memory is mapped to extended memory starting at the 1M byte boundary.

System Memory Map

The Little Board/486e CPU address up to 64M bytes of me mory. Table 2–6 shows how th is memo ry
is used.
The first megabyte stores the following data starting at memory address 00000h:
! DRAM
! Byte-wide socket
! ROM BIOS