Ampro Corporation 700 manual Chapter

Chapter 2 Product Overview

♦Supports dual bus master mode

♦Supports Ultra DMA 33/66/100 modes

♦Supports ATAPI and DVD peripherals

♦Supports IDE native and ATA compatibility modes

♦CompactFlash Adapter (Secondary IDE only)

•Supports Type I or Type II PC Card socket

•Supports IDE CompactFlash Card

•Supports secondary IDE bus with Master/Slave jumper

•Supports bootable CompactFlash card

•Floppy/Parallel Interface

♦Shared floppy/parallel connector

♦Supports one standard (34-pin) floppy drive and one USB floppy drive

♦Supports all standard PC/AT formats: 360KB, 1.2MB, 720KB, 1.44MB, 2.88MB

♦Supports a standard printer port

♦Supports IEEE standard 1284 protocols of EPP and ECP outputs

♦Bi-directional data lines

♦Supports 16 byte FIFO for ECP mode

•Serial Ports

♦Four buffered serial ports with full handshaking

♦Supports two DB9 connectors Serial 1 & 2 (COM1 & COM2)

♦Supports two serial ports Serial 3 & 4 (COM3 & COM4) through 20-pin header

♦Provides 16550-equivalent controllers, each with a built-in 16-byte FIFO buffer

♦Supports full modem capability and RS232 on all four ports

♦Supports RS485 or RS422 operation two ports Serial 3 & 4 (COM3 & COM4)

♦Supports programmable word length, stop bits, and parity

♦Supports 16-bit programmable baud-rate generator and a interrupt generator

•Infrared Interface

♦Supports IrDA 1.1 on separate connector (J17)

♦Supports HPSIR and ASKIR infrared modes

♦Support IR mode select from the Southbridge

•USB Ports

♦Supports two root USB hubs

♦Supports up to four USB ports

♦Supports two standard USB connectors (USB 0 & 1) and one 10-pin header (USB 2 & 3)

♦Supports USB v1.1 and Universal OHCI v1.1

♦Supports over-current fuses on board

•Keyboard/Mouse Interface

♦Supports PS/2 keyboard

ReadyBoard 700 Reference Manual 7