mUse the Memory control panel to turn off virtual memory. For more information on virtual memory, see the information about memory in Macintosh Guide (or Mac OS Guide), available in the Guide (h) menu.
Note: If you turn on both virtual memory and RAM disk in the Memory control panel, don’t set both of them at or near their maximum values. Doing so can result in unpredictable or reduced performance by your computer. (RAM disk uses
mIf you still do not notice an improvement, you may want to reinstall system software on your startup hard disk. See Chapter 11, “Diagnostic Techniques,” for instructions.
mIf you typically use several application programs at the same time, your computer’s performance will increase if you install more
Your computer isn’t performing as fast as you’d like.
If, after trying the tips in the previous section, your computer still isn’t performing as fast as you’d like, try these suggestions. Each one will make only a small difference in your computer’s speed; but if you try them all, you’ll notice the improvement.
mOpen the Memory control panel in the Control Panels folder in the Apple (K) menu; then make these changes:
m In the Disk Cache section, increase the Cache Size slightly. (Because the amount of memory available for opening programs decreases as you increase the size of the cache, do not set the Cache Size too high.)
m In the Modern Memory Manager section, click On.
m In the Virtual Memory section, click Off if you haven’t already done so.
mOpen the Keyboard control panel in the Control Panels folder; then make these changes:
m Set the Key Repeat Rate to Fast.
m Set the Delay Until Repeat to Short.
mTurn off Menu Blinking. Open the General Controls control panel in the Control Panels folder; then click Off in the Menu Blinking section.
172 | Chapter 10 |
