Adjustment Normal 16/Super 16

Adjusting the Viewfinder Alignment

Loosen the threaded bushing with special wrench A 16 SR-3 by approx. 2 full turns.

Loosen the worm screw SW 2 by approx. 10 full turns.

Remove the threaded bushing .

Hold the knurled ring firmly and completely

unscrew the worm screw .

Untwist the knurled ring and remove the viewfinder.

Unscrew the 4 cylinder head screws .

Turn the friction flange 180° . The desired format (N or S) must be legible.

Replace the 4 cylinder head screws and screw tight.

Clean the visible lens surfaces carefully with a moist optic cloth. If dirt clings, moisten the optic cloth with pure alcohol.

Remount the viewfinder in the reversed order. Adjust the friction. See chapter 6.

When replacing the viewfinder never forget the friction plate as otherwise the function of the optic will be impaired.

swingover friction

helical retaining ring

adjustment

 

hex screws

52