Video-Assist-System

Note: If the video carrying handle remains on the camera when dismounting, the opening on the carrying handle should be closed over with the supplied protective cover.

Wiring the Video-Assist-System

•Plug the anti flicker processor AFP-2 through the socket MOVIE CAMERA with cable KC 37 into one of the RS-sockets on the camera.

•Plug cable KC 34 into the socket VIDEO CAMERA on the anti flicker processor AFP-2 and into the video camera.

The video signal for the monitor is possible on two sockets on the anti flicker processor AFP-2:

Minimonitor:socket MINI MONITOR

Standard video monitor: BNC-socket VIDEO OUT

The BNC-socket „VD“ on the video camera CCD 2-FR is used for synchronization with an external video signal. Do not use as a video output!

•Set the code switch on the underside of the anti flicker processor to „A“.

•Adjust focussing and image position on the video camera. See below.

Adjusting the Video Optic

Adjusting the Image Position

•Loosen the clamp ring approx. 15° (as seen in the direction of shooting, counter-clockwise).

•Adjust the angle position by turning the CCD-camera, at the same time checking the image on the monitor.

•Set the width position with the adjustment screw

SW 1,3, taking care that on loosening the adjustment screw the image follows, otherwise press the CCD- camera at the screw-on position slightly upwards.

•Retighten the clamp ring.

Adjusting Focus

•Loosen the aperture clamp with the aperture adjust-

ment knob ; this also unlocks the focussing

adjustment ring .

•Completely open the aperture.

•Set focus through the monitor with the focussing adjustment ring.

•Set the aperture to the monitor.

•Pull tight the aperture clamp.

78