Display and Operating Elements

Film Counter

Switching the Total Exposed Film/Take Counter

The film counter can only be switched from total exposed film to take counter while in Standby. The take counter is reset every time the camera is restarted. The total counter is reset by hand. To switch:

Switch the MODE key to mode 3 (take or total exposed film counter/power supply).

Depress the SEL key twice - the first position on the counter flashes.

With the SET key it is possible to switch between „t“ take counter and total exposed film counter.

If the take counter is set the total counter will be shown in mode 1 (standard), and vice versa.

Resetting the Total Exposed Film Counter The total exposed film counter can only be reset while in Standby:

Switch the MODE key to the mode in which the total exposed film counter is displayed (mode 1 or 3).

Depress the SET key for approx. 3 sec - the counter resets.

Switching from Meters to Feet

The film counter can only be switched between meters and feet while in Standby. To do this:

Switch the MODE key to mode 3 (take or total exposed film counter/power supply). Press the SEL key once - „m“ or „ft“ flashes.

Enter the desired unit of measurement with the SET key.

Summary of Modes

On the following pages the modes are displayed in a table and examples for each mode are given.

58