Choosing Standard Speed

•Set the sliding switch to NORM.

•Switch the MODE key to mode 1 (standard).

•Switch through on the SEL key to the desired speed - the speed flashes approx. 3 sec. After 3 sec the previously set speed will reappear.

•While the light is blinking depress the SET key to set the speed.

Choosing Programmable Speed in Advance

•Set the sliding switch to PS.

•Switch the MODE key to mode 2 (programmable speed).

•Enter the positions to be changed with the SEL key. Switch each chosen position with the SET key until the desired value is displayed. Enter the next position to be changed using the SEL key, or after the third position after the comma finish the setting. The third position after the comma (1/1000 fps) is in the upper line in the right-hand corner. On the HS camera the display switches to the speed indicator of 100 to 150 fps if the first digit of the speed indicator is switched above value 9. Speed can then only be set to 1/10 fps (neither 1/100 nor 1/1000 fps).

The last position (1/1000 fps) can also be changed while the camera is running in order to manually fine- tune camera frame speed (see synchronization on a video monitor).

Changing the Programmable Speed while the Camera is Running

While the camera is runing only the last position (1/1000 fps) of the programmable speed can be changed.

•Set the sliding switch to PS.

•The camera runs in RUN.

•Switch the MODE key to mode 2 (programmable speed).

•Decrease speed with the SEL key, increase speed with the SET key.

Setting Speed from the Accessories

See chapter 10.

Display and Operating Elements

57