General Information | Asante Technologies 3500 Series specs

System Unit Map

=================

Please select one of the following slots

Slot	Description (Unit Type)
----	-------------------------------------------
1	IntraCore 3524 Unit
2	IntraCore 3524 Unit
3	IntraCore 3524 Unit
4	IntraCore 3524 Unit
5	IntraCore 3524	Unit
6	IntraCore 3524	Unit
7	IntraCore 3524	Unit
8	IntraCore 3524	Unit

Enter Unit Number (1 - 8) >

Exiting a Submenu

To exit a submenu, type q.

To exit a command line without changing the configuration setting (e.g., the “Set Password” option in the User Interface Configuration Menu), press ctrl-c.

3.1 General Information

The General Information Screen displays the current operating information of the switch, such as its name, IP address, and boot information.

To view General Information, type g from the Main Menu. A screen similar to that below appears.

IntraCore 3524 General Information Menu

System up for: 001day(s), 17hr(s), 27min(s), 54sec(s)

Software Version

Bank 1 Image Version/Date: 1.10/Dec 05 2001 13:54:06

Bank 2 Image Version/Date: 1.10/Dec 05 2001 13:54:06 (Running)

System Information

PROM Image Version/Date: 1.03D/Oct 06 2001 15:29:58

DRAM Size:	16.0MB		Flash Size:	2.0MB
Config NVRAM	Size:	64KB	Console Baud Rate: 9600 bps
Administration	Information
System Name:	Test Stack

System Location:

System Contact:

System MAC Address, IP Address, Subnet Mask and Router

MAC Address:	00:00:94:CC:C7:6D
IP Address:	xxx.xxx.xxx.xxx
Subnet Mask:	255.255.255.0
Router:	0.0.0.0
Bootstrap Configuration
Boot Load Mode:	LOCAL

Press any key to continue...

Note: The information displayed on this screen is read-only.

To exit the General Information Screen, press any key on your keyboard.

3.2 Configuration Menu

The Configuration Menu allows you to manage and configure switch and each of its ports.

To access the Configuration Menu, type c from the Main Menu. The Configuration Menu appears, as shown below (from a telnet session):

23

Image 23

Asante Technologies 3500 Series user manual General Information, Configuration Menu, Exiting a Submenu

Contents

IntraCore 3500 Series Quick Start Guide IntraCore 3500 Series Gigabit Ethernet Switches User’s Manual Table of Contents Page Introduction Package Contents 1 IC3524 Models LEDs 4810/100 2 IC3548-2GT #49 Front and Back Panel Descriptions Management and Configuration Snmp Management Console InterfaceWeb-Based Interface Safety Overview Hardware Installation and SetupInstallation Overview Environmental Requirements Installation into an Equipment RackRecommended Installation Tools Power Requirements Equipment Rack Guidelines Installing a GbicGbic Interfaces Gbic Care and Handling Installing Optional Hardware ModulesConnecting Power Removing a Gbic 1 10/100BaseT Ports Cabling Procedures Connecting to the Network Connecting to a Console SetupGigabit Ethernet Ports Cabling Procedures Connecting Via Telnet Changing the PasswordConnecting Via the Web Browser Snmp Management IP Assignment Using the Stacking Feature IC3524 only Toggle Stacking Enable/Disable Logging ConfigurationAccessing a Submenu Exiting a Submenu Configuration MenuGeneral Information Changing System Administration Info System Administration Configuration Changing System IP Information System IP ConfigurationBootstrap Configuration Changing Community Strings Snmp Configuration Deleting a Trap Receiver Enabling Authentication TrapsAdding or Updating a Trap Receiver Basic Port Configuration Menu appears Port Configuration Enabling or Disabling a Port Configuring Auto-Negotiation Toggling Half to Full Duplex Configuring a Port ManuallyConfiguring 1000BaseX Ports Toggling Port Link Speed Enabling or Disabling 802.3x Flow Control Advanced Port ConfigurationSetting Port Class of Service Global Port Configuration Setting Port Default Priority Displaying the Forwarding Database Unicast Forwarding Database Configuration Searching for a MAC Address Setting the MAC Address Age-Out Time IP Multicast Traffic Management Port Mirroring ConfigurationSecurity Management Vlan Management Image Downloading through Tftp File Up/Downloading ConfigurationSetting the Monitor Port Performing a Software Upgrade at Runtime Serial Downloading Configuration Performing a Software Upgrade System Reset ConfigurationResetting the Switch System Log Scheduling a System Reset Clearing the System Log User Interface Configuration Setting Telnet Idle Time-out Period Setting Console Idle Time-out Period Enabling or Disabling the Web Server Changing the PasswordSystem Utility Viewing Statistics Enabling and Disabling STP Configuring Spanning Tree ParametersAdvanced Management Spanning Tree Protocol Setting Port Priority and Path Cost Spanning Tree Port Configuration Rmon Management Snmp and Rmon ManagementDuplicated IP Detection and Trap Viewing a List of Duplicated IP Addresses Enabling and Disabling Station Movement TrapEnabling and Disabling Duplicated IP Detection Enabling and Disabling Duplicated IP Trap Configuring Port New Node Detection Trap Configuring Port Security Setting the Intruder Trap Configuring Port Lock and Intruder LockConfiguring Security Level 2 or Level Inserting/Modifying a Port Trusted MAC Address Vlan Specifications for the IntraCore 3500 SeriesResetting Security to Defaults Other Vlan Features of the switch Kkxxxxxx Kxxxxxxx Configuring Static Vlan Groups Advanced Static Vlan Configuration Specifying Tagging or No Tagging for a Port Configuring Vlan Port AttributesSetting the Port Vlan ID Adding and Deleting VLANs from the Port Configuring Port Receive Frame TypeDisplaying a Summary of Vlan Groups Displaying a Vlan Port Summary Multicast Addresses Resetting Vlan Configuration to Defaults Displaying a Summary of Group Addresses Configuring IP Multicast Traffic ManagementIgmp Snooping Enabling and Disabling Igmp Snooping Removing a Multicast Group Address To remove an address IP Multicast Forwarding Database ConfigurationAdding Ports to the Selected Address Inserting a Multicast Group Address Web-Based Management Accessing with a Web Browser Genl Info General Information Button Front Panel Button Statistics Button Port Config Port Configuration Button Span Tree Spanning Tree Button Addr Address Table Button Snmp Button Vlan Button Port Configuration Adding and Deleting Port Members Vlan ConfigurationCreating or Modifying a Vlan Page Security Button Duplicate IP Button Snmp Protocol Snmp ManagementSnmp Management Operations MIB Groups Supported Community Name and SecurityMIB Tree Name Space PathPage Vlan ID and Tagged Frames Switching ConceptsVLANs Port-Based VLANs Spanning Tree Parameters Port Vlan IDHow It Works Port Priority Forward DelayFull Duplex, Flow Control and Auto-negotiation Full Duplex Auto-Negotiation Flow Control Problem Possible Solutions Appendix A. Troubleshooting Specifications Appendix B. Features and SpecificationsFeatures Standards Compliance Physical CharacteristicsTechnical Support and Warranty Environmental Range IntraCare Warranty Statement Appendix C. FCC Compliance and Warranty StatementsFCC Compliance Statement Important Safety Instructions Page Appendix D. Console Port Pin Outs Pin Number Signal Name Appendix E. Online Warranty Registration Loading Software Locally Appendix F. BootP ConfigurationBootstrap Configuration Image Banks