KVM Over the NET™ User Manual
LDAP / LDAPS Authentication and Authorization Settings
To allow authentication and authorization for the KVM Over the NETTM switch via LDAP / LDAPS, refer to the information in the table, below:
Item | Action |
|
|
Enable | Put a check in the Enable checkbox to allow LDAP / LDAPS |
| authentication and authorization. |
|
|
Type | Click a radio button to specify whether to use LDAP or LDAPS. |
|
|
LDAP Server IP and | Fill in the IP address and port number for the LDAP or LDAPS |
Port | server. For LDAP, the default port number is 389; for LDAPS, |
| the default port number is 636. |
|
|
Admin DN | Consult the LDAP / LDAPS administrator to ascertain the |
| appropriate entry for this field. For example, the entry might |
| look like this: |
| ou=kn4132,dc=aten,dc=com |
|
|
Admin Name | Key in the LDAP administrator’s username. |
|
|
Password | Key in the LDAP administrator’s password. |
|
|
Search DN | Set the distinguished name of the search base. This is the |
| domain name where the search starts for user names. |
|
|
Timeout | Set the time in seconds that the KVM Over the NETTM |
| switch waits for an LDAP or LDAPS server reply before it times |
| out. |
|
|
Note: If LDAP Settings is enabled, the LDAP schema for MS Active Directory must be extended. See LDAP Server Configuration, page 173, for details.
CC Management Settings
To allow authorization for the KVM Over the NETTM switch through a CC (Control Center) server, check Enable and fill in the CC Server’s IP address and the port that it listens on in the appropriate fields.
132