KVM Over the NET™ User Manual

4.Plug a cable from the LAN or WAN into the KVM Over the NETTM switch primary network interface socket.

5.(Optional) Plug another cable from the LAN or WAN into the KVM Over the NETTM switch backup (secondary) network interface socket.

6.(Optional) Use Cat 5e cable to connect the KVM Over the NETTM switch PON port to an SA0142 Adapter. Connect the Adapter to the PON IN port of a PN0108 Power Over the Net™ unit.

7.(Optional) Use Cat 5e cable to connect the KVM Over the NETTM switch Modem port to an SA0142 Adapter. Connect the Adapter’s serial connector to the modem’s DB-9 port.

8.Use the grounding wire supplied with this package to ground the unit by connecting one end of the wire to the grounding terminal, and the other end of the wire to a suitable grounded object.

Note: Do not omit this step. Proper grounding helps to prevent damage to the unit from surges or static electricity.

9.Plug the power cord(s) supplied with this package into the KVM Over the NETTM switch power socket, and then into an AC power source.

For the KN2124v, KN2140v, KN4124v and KN4140v, when using a single power socket, be sure to turn on the correct power switch (see Power Switch, page 13). When using both power sockets, either of the power switches can be used to turn on the KVM switch – or, to enable dual power, turn on both power switches.

Note: If you are connecting the power to a UPS or an ALTUSEN PN9108/ PN0108 use the utility power cords supplied with this package instead of the standard power cords.

After the KVM Over the NETTM switch is cabled up you can turn on the power. After it is powered up, you can turn on the servers.

22